First Results of the DITO-Experiment at the HARWI II Beamline at GKSS/DESY
p.201
p.201
Diffraction Contrast Tomography - A Synchrotron Radiation Technique for Mapping Polycrystalline Microstructures in 3D
p.207
p.207
Kowari – The Residual-Stress Diffractometer for Engineering Applications at OPAL
p.213
p.213
A Critical Discussion of the sin2ψ Stress Measurement Technique
p.219
p.219
Measurement of all Six Components of X-Ray Elastic Factors
p.225
p.225
Use of Stored Energy Distribution in Stochastic Vertex Model
p.231
p.231
Imaging Diffraction Using Maxim at G3/Hasylab - Spatial Resolved Strain Measurements on Linear Friction Welded Dissimilar Materials (AA7020-T6/Ti6AlV
p.237
p.237
Two-Dimensional Mapping of Crack-Face Bridging Stresses in Alumina Using Synchrotron Micro X-Ray Beam
p.243
p.243
Application of Synchrotron Radiation to Residual Stress Analysis by IP/cosα Method
p.249
p.249
Measurement of all Six Components of X-Ray Elastic Factors
Abstract:
A method is presented by which all components of Fij(ϕ, ψ, hkl) belonging to the same measurement direction and reflection can be determined. The neutron measurements are to be done with a single specimen, shaped as a cuboctahedron. An apparatus for producing a compressive stress state in the specimen is needed. It must be small enough to fit into the neutron goniometer and to allow movement of the goniometer to all Eulerian angles. Using this set-up the tensors F(ϕ, ψ, hkl) can be measured for any ϕ, ψ and (hkl).
You might also be interested in these eBooks
Info:
Periodical:
Materials Science Forum (Volumes 571-572)
Pages:
225-229
Citation:
Online since:
March 2008
Authors:
Keywords:
Price:
Permissions: