Document Type : Research Article

Authors

Department of Mechanical Engineering, Urmia University of Technology, Urmia, Iran.

Abstract

In this paper, a three-dimensional, single-phase proton-exchange membrane fuel cell (PEMFC) is studied numerically. Finite volume method was used for solving the governing equations and, consequently, the numerical results were validated by comparing them with experimental data, which showed good agreement. The main objective of this work is to investigate the effect of a novel gas channel shape– by applying sinusoidal gas channel- on the cell performance and mass transport phenomena. Some parameters such as oxygen consumption, water production, protonic conductivity, and temperature distribution for two cell voltages were studied, and the results were compared with respect to conventional and new models.    The results indicated that the new novel model showed better performance than the conventional model, especially at low cell voltages, causing an increase in oxygen consumption and water production. Therefore, based on a number of investigated relations, a higher rate of current density was obtained, thus enhancing the fuel cell performance. This is because the incoming species path to the gas channels in the  new model becomes longer. Therefore, the diffusion of the species toward the electrochemical reaction area increased.

Keywords

Main Subjects

1.     Kreuer, K.D., Ed., Fuel cells, Springer, New York, (2013). (https://doi.org/10.1007/978-1-4614-5785-5).
2.     Bernardi, D.M. and Verbrugge, M.W., "Mathematical model of a gas diffusion electrode bonded to a polymer electrolyte", AIChE Journal, Vol. 37, No. 8, (1991), 1151-1163. (https://doi.org/ 10.1002/aic.690370805).
3.     Bernardi, D.M. and Verbrugge, M.W., "A mathematical model of the solid-polymer-electrolyte fuel cell", Journal of The Electrochemical Society, Vol. 139, No. 9, (1992), 2477-2491. (https://doi.org/10.1149/1.2221251).
4.     Fuller, T.F. and Newman, J., "Water and thermal management in solid-polymer-electrolyte fuel cells", Journal of The Electrochemical Society, Vol. 140, No. 5, (1993), 1218-1225. (https://doi.org/10.1149/1.2220960).
5.     Nguyen, T.V. and White, R.E., "Water and heat management model for proton-exchange-membrane fuel cells", Journal of The Electrochemical Society, Vol. 140, (1993), 2178-2186. (https://doi.org/10.1149/1.2220792).
6.     Dutta, S., Shimpalee, S. and Van Zee, J.W., "Three-dimensional numerical simulation of straight channel PEM fuel cells", Journal of Applied Electrochemical, Vol. 30, (2000), 135-146. (https://doi.org/10.1023/a:1003964201327).
7.     Berning, T. and Djilali, N., "Three-dimensional computational analysis of transport phenomena in a PEM fuel cell: A parametric study", Journal of Power Source, Vol. 124, (2003), 440-452. (https://doi.org/10.1016/s0378-7753(03)00816-4).
8.     Yang, T.-H., Park, G.-G., Pugazhendhi, P., Lee, W.-Y. and Kim, C.S., "Performance improvement of electrode for polymer electrolyte membrane fuel cell", Korean Journal of Chemical Engineering, Vol. 19, No. 3, (2002), 417-420. (https://doi.org/10.1007/bf02697149).
9.     Molaeimanesh, Gh. and Akbari, M.H., "Water droplet dynamic behavior during removal from a proton exchange membrane fuel cell gas diffusion layer by Lattice-Boltzmann method", Korean Journal of Chemical Engineering, Vol. 31, No. 4, (2014), 598-610. (https://doi.org/10.1007/s11814-013-0282-6).
10.   Carral, Ch. and Mélé, P., "A numerical analysis of PEMFC stack assembly through a 3D finite element model", International Journal of Hydrogen Energy, Vol. 39, No. 9, (2014), 4516-4530. (https://doi.org/10.1016/j.ijhydene.2014.01.036).
11.   Ahmadi, N., Dadvand, A., Rezazadeh, S. and Mirzaee, I., "Analysis of the operating pressure and GDL geometrical configuration effect on PEM fuel cell performance", Journal of The Brazilian Society of Mechanical Science and Engineering, (2016). (https://doi.org/10.1007/s40430-016-0548-0).
12.   Rezazadeh, S. and Ahmadi, N., "Numerical investigation of gas channel shape effect on proton exchange membrane fuel cell performance", Journal of The Brazilian Society of Mechanical Sciences and Engineering, (2015). (https://doi.org/10.1007/ s40430-014-0209-0).
13.   Ticianelli, E.A., Derouin, C.R., Redondo, A. and Srinivasan, S., "Methods to advance technology of proton exchange membrane fuel cell", Journal of Electrochemical Society, Vol. 135, No. 9, (1988), 2209-2214. (https://doi.org/10.1149/1.2096240).
14.   Ahmadi, N., Pourmahmoud, N., Mirzaee I. and Rezazadeh, S., "Three-dimensional computational fluid dynamic study of effect of different channel and shoulder geometries on cell performance", Australian Journal of Basic and Applied Sciences, Vol. 5, No. 12, (2011), 541-556.
15.   Ahmadi, N., Rezazadeh, S., Mirzaee, I. and Pourmahmoud., N., "Three-dimensional computational fluid dynamic analysis of the conventional PEM fuel cell and investigation of prominent gas diffusion layers effect", Journal of Mechanical Science and Technology, Vol. 26, No. 8, (2012), 2247-2257. (https://doi.org/10.1007/s12206-012-0606-1).
16.   Wang, L., Husar, A., Zhou,T. and Liu, H., "A parametric study of PEM fuel cell performances", International Journal of Hydrogen Energy, Vol. 28, No. 11, (2003), 1263-1272. (https://doi.org/10.1016/s0360-3199(02)00284-7).
17.   Ahmadi, N., Rezazadeh, S. and Mirzaee, I., "Study the effect of various operating parameters of proton exchange membrane", Periodica Polytechnica. Chemical Engineering, Vol. 59, No. 3, (2015), 221-235. (https://doi.org/10.3311/ppch.7577).
18.   Ahmadi, N., Rezazadeh, S., Dadvand, A. and Mirzaee, I., "Modelling of gas transport in proton exchange membrane fuel cells", Institution of Civil Engineers (ICE), Vol. 170, No. 4, (2017), 163-179. (https://doi.org/10.1680/jener.15.00015).
19.   Ahmadi, N., Rezazadeh, S., Dadvand, A. and Mirzaee, I., "Numerical investigation of the effect of gas diffusion layer with semicircular prominences on polymer exchange membrane fuel cell performance and species distribution", Journal of Renewable Energy and Environment (JREE), Vol. 2, No. 2, (2015), 36-46.
20.   Rezazadeh, S., Mirzaee, I., Pourmahmoud and Ahmadi, N., "Three dimensional computational fluid dynamics analysis of a proton exchange membrane fuel cell”, Journal of Renewable Energy and Environment (JREE), (2014).