Experimental study of the effect of polymer fiber based on epoxy resin on compressive and exural strength parameters

Document Type : Article

Authors

Department of Civil Engineering, Mahabad Branch, Islamic Azad University, Mahabad, P.O. Box 59133-43345, Iran.

Abstract

In this study, effective parameters on polymer concrete (PC) based on epoxy resin such as filler, hardener and solvent are investigated. Rice husk and broom stem ashes as fillers with mixture of 50-50% Acetone-Toluene as solvent in preparation of PC samples were used. According to experimental results, addition of fillers improved compressive, flexural and chemical strengths of the PC samples. In the sample with 18.4% polymer, additional of rice husk ash with ratio of filler-aggregate 0.075, compressive strength improved by 21%. For the sample with broom stem ash ratio of filler-aggregate 0.09, the flexural strength was improved by 27%. In addition, experimental data proved that addition of optimum amount of solvent improved the performance and enhanced the compressive and flexural strengths. But excess amount of solvent may reduce the adhesiveness of the polymer therefore it may have negative impact on PC. The combination of hardener-resin may influence on the strength of PC. Amine type of hardener with low equivalent weight improved 27 and 13% on compressive and flexural strengths. Also elasticity module was increased in compare with the samples having high equivalent weight of amine type hardener.

Keywords

Main Subjects

References

References:
1. Riberio, M.C.S., Novoa, P.R., and Ferreira, A.J.M. "Flexural performance of polyester and epoxy polymer mortars under severe thermal conditions", Cement & Concrete Composition, 26, pp. 803-809 (2004).
2. Mohammadhassani, M., Meldi, S., Shariati, M., and Ghanbari, F. "Ductility and strength assessment of HSC beams with varying of tensile reinforcement ratios", Str. Eng. and Mech., 48(6), pp. 833-848 (2013).
3. Sinaei, H., Jumaat, M.H., and Shariati, M. "Numerical investigation on exterior reinforced concrete Beam-Column joint strengthened by composite fiber reinforced polymer (CFRP)", Int. J. of Physical Sci., 6(28), pp. 6572-6579 (2011).
4. Mohammadhassani, M., Nezamabadi-pour, H., Meldi, S., and Shariati, M. "An evolutionary fuzzy modelling approach and comparison of different methods for shear strength prediction of high-strength concrete beams without stirrups", Smart Str. and Sys., 14(5), pp. 785-809 (2014).
5. Zhang, P. and Li, Q.-F. "Combined effect of silica fume and polypropylene fiberon drying shrinkage properties of concrete composites containing y ash", Scientia Iranica, 20(5), pp. 1372-1380 (2013).
6. Papadakisa, V.G. "Experimental investigation and theoretical modeling of silica fume activity in concrete", Cem. and Con. Res., 29(1), pp. 79-86 (1999).
7. Bhikshma, V., Nitturkar, K., and Venkatesham, Y. "Investigations on mechanical properties of high strength silica fume concrete", Asian J. of Civil Eng., 10(3), pp. 335-346 (2009).
8. Bayasi, Z. and Zhou, J. "Properties of silica fume concrete and mortar", Aci Materials J., 90(4), pp. 349-356 (1993).
9. Siddique, R. "Utilization of silica fume in concrete: Review of hardened properties", Resources, Conserv. and Recycling, 55(11), pp. 923-932 (2011).
10. Ozawa, M. and Morimoto, H. "Effects of various fibres on high-temperature spalling in high-performance concrete", Constr. Build. Mater., 71, pp. 83-92 (2014).
11. Kodur, V. "Properties of concrete at elevated temperatures", ISRN Civ. Eng., 2014, pp. 1-15 (2014).
12. Unterweger, C., Bruggemann, O., and Furst, C. "Effects of different fibers on the properties of short-fiberreinforced polypropylene composites", Combust. Sci. Technol., 13, pp. 49-55 (2014a).
13. Unterweger, C., Bruggemann, O., and Furst, C. "Synthetic fibers and thermoplastic short-fiber-reinforced polymers: properties and characterization", Polym. Compos., 35, pp. 227-236 (2014b).
14. Rahmanzadeh, B., Rahmani, K., and Piroti, S. "Experimental study of the effect of water-cement ratio on compressive strength, abrasion resistance, porosity and permeability of nano silica concrete", Frattura ed Integrita Strutturale, 44, pp. 16-24 (2018).
15. Rahmani, K., Ghaemoan, M., and Hosseini, A. "Experimental study of the effect of water to cement ratio on mechanical and durability properties of nano-silica concretes with polypropylene fibers", Scientia Iranica, 26(5), pp. 2712-2722 (2019).
16. Kheyroddin, A., Bazzaz, M., Famili Fard, P., and Andalib, Z. "High performance and special concrete", In 14th International Civil Engineering Student Conference, Semnan, Iran, pp. 1-12 (2008).
17. Sharbatdar, M.K., Bazzaz, M., Kashiha, N., and Andalib, Z. "Behavior of fiber concrete under impact and explosive load", In 14th International Civil Engineering Student Conference, Semnan, Iran, pp. 1-11 (2008).
18. Kheyroddin, A., Kashiha, N., Bazzaz, M., and Andalib, Z. "Application of post tensioning in concrete slab", In 14th International Civil Engineering Student Conference, Semnan, Iran, pp. 1-15 (2008).
19. Gerami, M., Bazzaz, M., Andalib, Z., and Bazzaz, M. "Retrofit of reinforced concrete frame with steel bracing system", In 14th International Civil Engineering Student Conference, Semnan, Iran, pp. 1-17 (2008).
Scientia Iranica
Volume 27, Issue 4
Transactions on Civil Engineering (A)
July and August 2020
Pages 1803-1813

Files

Share

How to cite

Statistics