Vortex Diode Analysis and Testing for Fluoride Salt-Cooled High-Temperature Reactors
- ORNL
- Texas A&M University, Kingsville
- University of Tennessee, Knoxville (UTK)
Fluidic diodes are presently being considered for use in several fluoride salt-cooled high-temperature reactor designs. A fluidic diode is a passive device that acts as a leaky check valve. These devices are installed in emergency heat removal systems that are designed to passively remove reactor decay heat using natural circulation. The direct reactor auxiliary cooling system (DRACS) uses DRACS salt-to-salt heat exchangers (DHXs) that operate in a path parallel to the core flow. Because of this geometry, under normal operating conditions some flow bypasses the core and flows through the DHX. A flow diode, operating in reverse direction, is-used to minimize this flow when the primary coolant pumps are in operation, while allowing forward flow through the DHX under natural circulation conditions. The DRACSs reject the core decay heat to the environment under loss-of-flow accident conditions and as such are a reactor safety feature. Fluidic diodes have not previously been used in an operating reactor system, and therefore their characteristics must be quantified to ensure successful operation. This report parametrically examines multiple design parameters of a vortex-type fluidic diode to determine the size of diode needed to reject a particular amount of decay heat. Additional calculations were performed to size a scaled diode that could be tested in the Oak Ridge National Laboratory Liquid Salt Flow Loop. These parametric studies have shown that a 152.4 mm diode could be used as a test article in that facility. A design for this diode is developed, and changes to the loop that will be necessary to test the diode are discussed. Initial testing of a scaled flow diode has been carried out in a water loop. The 150 mm diode design discussed above was modified to improve performance, and the final design tested was a 171.45 mm diameter vortex diode. The results of this testing indicate that diodicities of about 20 can be obtained for diodes of this size. Experimental results show similar trends as the computational fluid dynamics (CFD) results presented in this report; however, some differences exist that will need to be assessed in future studies. The results of this testing will be used to improve the diode design to be tested in the liquid salt loop system.
- Research Organization:
- Oak Ridge National Lab. (ORNL), Oak Ridge, TN (United States)
- Sponsoring Organization:
- USDOE
- DOE Contract Number:
- DE-AC05-00OR22725
- OSTI ID:
- 1036568
- Report Number(s):
- ORNL/TM-2011/425; RC0405000; NERC008; TRN: US1201520
- Country of Publication:
- United States
- Language:
- English
Similar Records
Scaling Analysis for the Direct Reactor Auxillary Cooling System For AHTRS
DRACS thermal performance evaluation for FHR
Related Subjects
ACCIDENTS
COMPUTERIZED SIMULATION
COOLANTS
COOLING SYSTEMS
DESIGN
FLUID MECHANICS
FLUORIDES
HEAT EXCHANGERS
LOSS OF FLOW
MOLTEN SALT COOLED REACTORS
NATURAL CONVECTION
ORNL
REACTOR SAFETY
REMOVAL
TESTING
Vortex Diode Fluoride fluidic salt-cooled high-temperature