Field programmable gate array-based fault-tolerant hysteresis current control for AC machine drives

H. Berriri; W. Naouar; I. Bahri; I. Slama-Belkhodja; E. Monmasson

Field programmable gate array-based fault-tolerant hysteresis current control for AC machine drives

Access Full Text

Field programmable gate array-based fault-tolerant hysteresis current control for AC machine drives

Author(s): H. Berriri ; W. Naouar ; I. Bahri ; I. Slama-Belkhodja ; E. Monmasson
DOI: 10.1049/iet-epa.2011.0053

For access to this article, please select a purchase option:

Buy article PDF

Buy Knowledge Pack

IET members benefit from discounts to all IET publications and free access to E&T Magazine. If you are an IET member, log in to your account and the discounts will automatically be applied.

Learn more about IET membership

Recommend Title Publication to library

IET Electric Power Applications — Recommend this title to your library

Thank you

Your recommendation has been sent to your librarian.

Author(s): H. Berriri ¹ ; W. Naouar ¹ ; I. Bahri ² ; I. Slama-Belkhodja ¹ ; E. Monmasson ²
- Affiliations: 1: Department of Electrical Engineering, University of Tunis El Manar, ENIT, LSE, Tunisia
  2: Department of Electrical Engineering, Université de Cergy Pontoise, SATIE-IUP GEII, Cergy-Pontoise, France
Source: Volume 6, Issue 3, March 2012, p. 181 – 189
DOI: 10.1049/iet-epa.2011.0053 , Print ISSN 1751-8660, Online ISSN 1751-8679

Published

This study presents a field programmable gate array (FPGA) implementation of a simple fault-tolerant control that ensures continuous operation of hysteresis current controlled AC machine drives under faulty current sensor. The adopted control requires the use of three current sensors and is available for three-phase isolated neutral systems. The third current sensor allows the faulty current sensor detection and isolation based on analytical redundancy that provides residuals with well-defined thresholds. The control is reconfigured in case of faulty current measurement and operation continuity is performed using the remaining two healthy sensors. The main interest of using FPGAs to implement such controllers is the very important reduction of execution time delay in spite of algorithm complexity. As a result, a high sampling frequency can be used and the residual thresholds can be accurately defined even for the experimental set-up. Numerous experimental results are given to illustrate the efficiency of FPGA-based solutions to achieve efficient and reliable fault-tolerant hysteresis current control of AC machine drives.

References

1. 1)
  - K. Rothenhagen , F.W. Fuchs . Current sensor fault detection, isolation, and reconfiguration for doubly fed induction generator. IEEE Trans. Ind. Electron. , 10 , 4239 - 4245
2. 2)
  - K. Rothenhagen , F.W. Fuchs . Doubly fed induction generator model-based sensor fault detection and control loop reconfiguration. IEEE Trans. Ind. Electron. , 4229 - 4238
3. 3)
  - Grandpierre, T., Lavarenne, C., Sorel, Y.: `Optimized rapid prototyping for real-time embedded heterogeneous multiprocessor', Seventh Int. Workshop on Hardware/Software Co-Design Conf. Proc., CODES’99, May 1999, Rome, Italy, CD Rom.
4. 4)
  - M.W. Naouar , E. Monmasson , A.A. Naassani , I.S. Belkhodja , N. Patin . FPGA-based current controllers for AC machine drives – a review. IEEE Trans. Ind. Electron. , 4 , 1907 - 1925
5. 5)
  - Karimi, S., Poure, P., Saadate, S., Gholipour, E.: `Current sensors and power switches fault detection and compensation for shunt active power filters', Proc. IEEE-ISIE, 4–7 June 2007, Vigo, Spain, p. 3157–3161, CD-ROM.
6. 6)
  - M.E. Romero , M.M. Seron , J.A. De Doná . Sensor fault-tolerant vector control of induction motors. IET Control Theory Appl. , 9 , 1707 - 1724
7. 7)
  - Bahri, I., Naouar, M.-W., Slama-Belkhodja, I., Monmasson, E.: `FPGA-based FDI of faulty current sensor in current controlled PWM converters', Proc. IEEE-EUROCON, 9–12 September 2007, Warsaw, Poland, CD-ROM.
8. 8)
  - Rotehhagen, K., Fuchs, F.W.: `Current sensor fault detection by bilinear observer for a doubly-fed induction generators', 32ndAnnual Conf. on IEEE Industrial Electronics, IECON 2006, November 2006, p. 1369–1374.
9. 9)
  - B.A. Welchko , T.A. Lipo , T.M. Jahns . Fault tolerant three-phase AC motor drive topologies: a comparison of features, cost and limitations. IEEE Trans. Power Electron. , 4 , 1108 - 1116
10. 10)
  - M. Abdellatif , M. Pietrzak-David , I. Slama-Belkhodja . DFIM vector control sensitivity with current sensor faults’ COMPEL. Int. J. Comput. Math. Electr. Electron. Eng. , 1 , 139 - 156
11. 11)
  - M.P. Kazmierkowski , L. Malesani . Current control techniques for three-phase voltage-source PWM converters: a survey. IEEE Trans. Ind. Electron. , 5 , 691 - 703
12. 12)
  - S. Skander Mustapha , I. Slama-Belkhodja . Current sensor failure in a DFIG wind-turbine: effect analysis, detection and control reconfiguration. Int. Rev. Electr. Eng. (I.R.E.E.) , 3 , 426 - 433
13. 13)
  - B.K. Bose . (2002) Modern power electronics and AC drives.
14. 14)
  - G.H. Yang , D. Ye . Adaptive fault-tolerant H-infinity control against sensor failures. IET Control Theory Appl. , 2 , 95 - 107
15. 15)
  - Jihen, A., Slama–Belkhodja, I.: `Investigation of fault tolerant of direct torque control in induction motor drive', Proc. PEMD, 31 March–2 April 2004, Edinburgh, UK, CD-ROM.
16. 16)
  - J.W. Bennett , B.C. Mecrow , D.J. Atkinson , G.J. Atkinson . Safety-critical design of electromechanical actuation systems in commercial aircraft. IET Electr. Power Appl. , 1 , 37 - 47
17. 17)
  - P.M. de la Barrera , G.R. Bossio , J.A. Solsona , G.O. Garcııa . Model for three-phase induction motors with stator core faults. IET Electr. Power Appl. , 8 , 591 - 602
18. 18)
  - S. Karimi , A. Gaillard , P. Poure , S. Saadate . Current sensor fault-tolerant control for WECS with DFIG. IEEE Trans. Ind. Electron. , 4660 - 4669
19. 19)
  - C.W. Chan , S. Hua , Z. Hong-Yue . Application of fully decoupled parity equation in fault detection and identification of DC motors. IEEE Trans. Ind. Electron. , 4 , 1277 - 1284
20. 20)
  - E. Monmasson , Y.A. Chapuis . Contributions of FPGA's to the control of electrical systems, a review. IEEE Ind. Electron. Soc. Newsl. , 4 , 8 - 15
21. 21)
  - R. Supangat , N. Ertugrul , W.L. Soong , D.A. Gray , C. Hansen , J. Grieger . Detection of broken rotor bars in induction motor using starting-current analysis and effects of loading. IEE Proc. Electr. Power Appl. , 6 , 848 - 855
22. 22)
  - M. Blanke , M. Kinnaert , J. Lunze , M. Staroswiecki . (2003) Diagnosis and fault-tolerant control.
23. 23)
  - E. Monmasson , M.N. Cirstea . FPGA design methodology for industrial control systems – a review. IEEE Trans. Ind. Electron. , 4 , 1824 - 1842
24. 24)
  - M. Gálvez-Carrillo , M. Kinnaert . Sensor fault detection and isolation in three-phase systems using a signal-based approach [Brief Paper]. IET Control Theory Appl. , 9 , 1838 - 1848
25. 25)
  - B. Trajin , J. Regnier , J. Faucher . Comparison between vibration and stator current analysis for the detection of bearing faults in asynchronous drives. IET Electr. Power Appl. , 2 , 90 - 100
26. 26)
  - H. Berriri , M.W. Naouar , I. Slama-Belkhodja . Easy and fast sensor fault detection and isolation algorithm for electrical drives. IEEE Trans. Power Electron. , 490 - 999

Login

Not registered yet?

Share

Tools

Login to add to favourites

Key

Field programmable gate array-based fault-tolerant hysteresis current control for AC machine drives

Field programmable gate array-based fault-tolerant hysteresis current control for AC machine drives

Buy article PDF

Buy Knowledge Pack

Thank you

References

Related content