Issue 11, 2024

From batch to flow: the effect of pH, current, and the crystal facets of Cu2O on electrochemical CO2 reduction

Abstract

As humanity is confronted by climate change, electrochemical CO2 reduction has become an important strategy for generating value-added chemicals whilst lowering carbon emissions. In this work, Cu2O nanoparticles with different morphologies and predominant exposed crystal facets, including nanocubes (Cu2O-NC) with (100) facets, nanoflowers (Cu2O-NF) with (110) facets, and octahedral structures (Cu2O-O) with (111) facets, are prepared, and compared as catalysts for the electrochemical CO2 reduction to C2+ products in a flow cell electrolyzer, to overcome the mass transfer limitations of CO2 in an H-cell and reach industrially relevant currents. To maximize the performance towards C2+ products, a parameter optimization (i.e. pH and current) was performed. Under the conditions of 150 mA cm−2 and pH of 8.5, the Cu2O-NC revealed a maximum faradaic efficiency of 58% for C2+ products. Similar studies in an H-cell system have shown lower total C2+ FE of around 35–40% for the nanocubes, indicating an improvement and showcasing the advantages of using a gas-fed flow electrolyzer. Finally, the long-term stability of these materials was also evaluated. The results revealed that C2+ activity remains constant for four hours at 50%. However, a sharp decline was observed after five hours when GDE flooding occurs, leading to a dominant HER. To confirm, the electrode was washed and dried before re-utilizing it. Since the Cu2O largely recovers its initial C2+ activity (from 50% to 43%) albeit with a slightly different product composition, this confirms GDE flooding as the main cause of degradation. During the eCO2RR, Cu2O is reduced to metallic Cu, as proven by in situ Raman. As a result, the particle morphology is roughened, which is proven by ex situ SEM images. Subsequently, water penetrates the gas diffusion electrode more easily, inhibiting the diffusion of CO2, and alongside the electrowetting effect results in GDE flooding. In conclusion, this work explores the utilization of different Cu2O catalysts in a flow electrolyzer, revealing insights into higher currents, their stability issues, crystal facet dependency, and reaction environment, which was unexplored in previous literature where the focus was on H-cell testing, which evaluates the catalysts under less demanding and more controlled conditions that are less relevant for up-scaling and eventual commercialization. Based on these new insights, further improvements can be made to enhance the total C2+ FE and improve stability.

Graphical abstract: From batch to flow: the effect of pH, current, and the crystal facets of Cu2O on electrochemical CO2 reduction

Supplementary files

Article information

Article type
Paper
Submitted
23 Jan 2024
Accepted
19 Apr 2024
First published
19 Apr 2024

Sustainable Energy Fuels, 2024,8, 2504-2518

From batch to flow: the effect of pH, current, and the crystal facets of Cu2O on electrochemical CO2 reduction

M. van der Veer, N. Daems, P. Cool and T. Breugelmans, Sustainable Energy Fuels, 2024, 8, 2504 DOI: 10.1039/D4SE00130C

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements