Main

We performed skin tests with 1- and 2-euro coins in seven patients known to have nickel-contact allergy. After 48 and 72 h with these coins fixed by transparent tape onto their skin, all seven patients showed a strong reaction, with erythema, infiltration and formation of vesicles; they showed no reaction to 1% zinc chloride in Vaseline or to 1% copper sulphate in water.

In a quantitative nickel-release test (the European Standard EN 1811; ref. 5), the 50-cent coin did not release a measurable amount of nickel, as expected. However, we found that the 1- and 2-euro coins released more nickel than pure nickel itself (Fig. 1). This was particularly high from the inner component (the 'pill') of the 1-euro coin, but not for the outer component (the 'ring'). These values are among the highest nickel-release rates ever measured on coins (see refs 6, 7 for a comparison).

Figure 1: Release of nickel from euro coinage compared with that from pure nickel in artificial sweat, as measured by the EN 1811 standard reference test5 (values here have not been divided by 10, as specified for the test).
figure 1

Release of nickel from the bimetallic 1- and 2-euro coins is higher than from pure nickel. Inset, corrosion of a 1-euro piece after partial immersion in artificial sweat for 36 h.

In the 1-euro coin, the ring is made of a yellow alloy ('nickel brass') that consists of copper with 20% zinc and 5% nickel by weight; the white ('cupro-nickel') pill is copper with 25% nickel by weight; in the 2-euro coin the ring is cupro-nickel and the pill is nickel brass. As 1- and 2-euro coins are bimetallic, we measured the galvanic potential between the two metals with a high-impedance voltmeter after mechanically separating the pill and ring of a freshly minted coin and immersing them in either artificial sweat or saturated NaCl solution.

We found a difference in electrode potential between the two metals (the yellow metal was more negative and the white more positive) that was dependent on time and on the electrical resistance of the connector. After immersion for 24 h at ambient temperature in either solution, the potential difference between the two alloys stabilized at 40 mV (it was about 30 mV during the first 10 hours, then drifted slowly upwards) for a resistance of 100 kΩ.

It is well known that a current can enhance galvanic corrosion and thereby cause more nickel release. In thin irregular electrolyte layers such as sweat deposits, galvanic corrosion should occur primarily near the bimetallic junction because of the high resistance to lateral current flow in the thin layer. We measured electrochemically the relative rates of corrosion of each alloy, and found that the yellow metal dissolves at least five times faster than the white in the active-corrosion range (results not shown). Therefore, although the yellow component contains only one-fifth of the nickel of the white, its rate of nickel release is as high as that from the white component, or possibly higher, because the contact areas of the two alloys with the skin are about the same.

Corrosion of the 1-euro coin is visible after immersion for 36 hours in artificial human sweat: the colours changed to brown and the surface structure was damaged (Fig. 1, inset). No corrosion is evident, however, in a Swiss 1-franc coin, which consists of 25% nickel and 75% copper, under these conditions (results not shown).

We conclude that the actual release of nickel from the present 1- and 2-euro coins exceeds the value acceptable for prolonged contact with human skin (as defined by European Union directive 94/27; ref. 1) by a factor of between 240 and 320 (Fig. 1). Whether or not this is acceptable by European standards hinges on the meaning of “prolonged” contact. Further investigation is warranted not only into the epidemiological implications of such high-nickel-releasing coins but also into the factors that promote nickel release, such as the crevice between the pill and the ring — a potential corrosion site.