Sorption of divalent metals on calcite

https://doi.org/10.1016/0016-7037(91)90127-QGet rights and content

Abstract

The sorption of seven divalent metals (Ba, Sr, Cd, Mn, Zn, Co, and Ni) was measured on calcite over a large initial metal (Me) concentration range (10−8 to 10−4 mol/L) in constant ionic strength (I = 0.1), equilibrium CaCO3(s)-CaCO3(aq) suspensions that varied in pH. At higher initial Me concentrations (10−5 to 1−4 mol/L) geochemical calculations indicated that the equilibrium solutions were saturated with discrete solid phases of the sorbates: CdCO3(s), MnCO3(s), Zn5(OH)6(CO3)2(s), Co(OH)2(s), and Ni(OH)2(s), implying that aqueous concentrations were governed by solubility. However, significant sorption of all the metals except for Ba and Sr was observed at aqueous concentrations below saturation with Me-solid phases. Divalent metal ion sorption was dependent on aqueous Ca concentration, and the following selectivity sequence was observed: Cd > Zn ≥ Mn > Co > Ni > Ba = Sr. The metals varied in their sorption reversibility, which was correlated with the single-ion hydration energies of the metal sorbates. The strongly hydrated metals (Zn, Co, and Ni) were most desorbable. A sorption model that included aqueous speciation and Me2+-Ca2+ exchange on cation-specific surface sites was developed that described most of the data well. The chemical nature of the surface complex used in this model was unspecified and could represent either a hydrated or dehydrated surface complex, or a surface precipitate. A single exchange constant for Cd, Mn, Co, and Ni could describe the sorption of that metal over a wide range in pH, Ca concentration, and surface concentration. Zinc, however, exhibited nonlinear sorption behavior and required exchange constants that varied with surface coverage. Our data suggested that (i) Cd and Mn dehydrate soon after their adsorption to calcite and form a phase that behaves like a surface precipitate, and (ii) Zn, Co, and Ni form surface complexes that remain hydrated until the ions are incorporated into the structure by recrystallization.

References (75)

  • W.A. Kornicker et al.

    The chemistry of Co2+ interaction with calcite and aragonite surfaces

    Chem. Geol.

    (1985)
  • R.W. Lahann et al.

    A kinetic model for distribution coefficients and application to Mg calcites

    Geochim. Cosmochim. Acta

    (1982)
  • R.B. Lorens

    Sr, Cd, Mn, and Co distribution coefficients in calcite as a function of calcite precipitation rate

    Geochim. Cosmochim. Acta

    (1981)
  • W.L. McIntire

    Trace element partition coefficients—A review of theory and application to geology

    Geochim. Cosmochim. Acta

    (1963)
  • P. Moller

    Determination of the composition of surface layers of calcite in solutions containing Mg2+

    J. Inorg. Nucl. Chem.

    (1973)
  • J.W. Morse

    The surface chemistry of calcium carbonate minerals in natural waters: An overview

    Mar. Chem.

    (1986)
  • A.A. Mozeto et al.

    Experimental observations on carbon isotope exchange in carbonate-water systems

    Geochim. Cosmochim. Acta

    (1984)
  • A. Mucci

    Growth kinetics and composition of magnesium calcite overgrowths precipitated from seawater: Quantitative influence of orthophosphate ions

    Geochim. Cosmochim Acta

    (1986)
  • A. Mucci et al.

    The incorporation of Mg2+ and Sr2+ into calcite overgrowths: Influences of growth rate and solution composition

    Geochim. Cosmochim. Acta

    (1983)
  • N.E. Pingitore et al.

    The experimental partitioning of Ba2+ into calcite

    Chem. Geol.

    (1984)
  • N.E. Pingitore et al.

    The coprecipitation of Sr2+ with calcite at 25°C and 1 atm

    Geochim. Cosmochim. Acta

    (1986)
  • N.E. Pingitore et al.

    The coprecipitation of manganese (II) with calcite: An experimental study

    Mar. Chem.

    (1988)
  • L.N. Plummer et al.

    Thermodynamics of aragonite-strontianite solid solutions: Results from stoichiometric solubility at 25 and 76°C

    Geochim. Cosmochim. Acta

    (1987)
  • R. Reeder et al.

    Sector zoning in calcite cement crystals: Implications for trace element distributions in carbonates

    Geochim. Cosmochim. Acta

    (1987)
  • C.S. Sastri et al.

    Study of the influence of Mg2+ ions on the Ca-Ca−45 isotopic exchange on the surface layers of calcite single crystals

    Chem. Phys. Lett.

    (1974)
  • D.W. Thompson et al.

    Surface electrical properties of calcite

    J. Colloid. Inter. Sci.

    (1989)
  • A. Tsusue et al.

    The coprecipitation of cations with CaCO3—III. The coprecipitation of Zn2+ with calcite between 50 and 250°C

    Geochim. Cosmochim. Acta

    (1966)
  • P. Wersin et al.

    From adsorption to precipitation: Sorption of Mn2+ on FeCO3(s)

    Geochim. Cosmochim. Acta

    (1989)
  • J.M. Zachara et al.

    The mechanism of Zn2+ adsorption on calcite

    Geochim. Cosmochim. Acta

    (1988)
  • J.M. Zachara et al.

    Solubility and surface spectroscopy of zinc precipitates on calcite

    Geochim. Cosmochim. Acta

    (1989)
  • J.J. Zullig et al.

    Interaction of organic acids with carbonate mineral surfaces in seawater and related solutions—I. Fatty acid adsorption

    Geochim. Cosmochim Acta

    (1988)
  • C.F. Baes et al.

    The Hydrolysis of Cations

    (1976)
  • J.W. Ball et al.

    Additional and revised thermochemical data and computer code for WATEQ2—A computerized chemical model for trace and major element speciation and mineral equilibria of natural waters

  • M.W. Bodine et al.

    Coprecipitation of manganese and strontium with calcite

  • J. Burgess

    Metal Ions in Solution

    (1978)
  • R.B. Corey

    Adsorption vs. precipitation

  • J.A. Davis et al.

    Surface Complexation Modeling in Aqueous Geochemistry

  • Cited by (434)

    View all citing articles on Scopus
    View full text