Skip to main content
Log in

Mass transfer of phosphorus in high-phosphorus hot-metal refining

  • Published:
International Journal of Minerals, Metallurgy, and Materials Aims and scope Submit manuscript

Abstract

Mass transfer of phosphorus in high-phosphorus hot-metal refining was investigated using CaO-Fe t O-SiO2 slags at 1623 K. Based on a two-film theory kinetic model and experimental results, it was found that the overall mass transfer coefficient, which includes the effects of mass transfer in both the slag phase and metal phase, is in the range of 0.0047 to 0.0240 cm/s. With the addition of a small amount of fluxing agents Al2O3 or Na2O into the slag, the overall mass transfer coefficient has an obvious increase. Silicon content in the hot metal also influences the overall mass transfer coefficient. The overall mass transfer coefficient in the lower [Si] heat is much higher than that in the higher [Si] heat. It is concluded that both fluxing agents and lower [Si] hot metal facilitate mass transfer of phosphorus in liquid phases. Furthermore, the addition of Na2O could also prevent rephosphorization at the end of the experiment.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Similar content being viewed by others

References

  1. J.Y. He, P. Zhou, G.Z. Zhuang, and J.H. Du, Study of dephosphorization process for high-phosphorus iron ore, Min. Eng., 6(2008), No. 2, p. 29.

    Google Scholar 

  2. J. Liu, G.Q. Li, C.Y. Zhu, and C.A. Wang, Research progress in treatment of high phosphorus iron ore and dephosphorization of high phosphorus hot metal, J. Mater. Metall., 6(2007), No. 3, p. 173.

    Google Scholar 

  3. P.K. Tripathy, A. Banerjee, B. Singh, D. Das, and A.K. Das, Approaches for conversion of high phosphorus hot metal to steel for flat products, ISIJ Int., 48(2008), No. 5, p. 578.

    Article  Google Scholar 

  4. Y.H. Wang, B. Xie, J. Diao, X.J. Li, and J.X. Zhang, Solubility in citric acid of dephosphorization slags from high phosphorus hot metal refining, J. Univ. Sci. Technol. Beijing, 33(2011), No. 3, p. 323.

    Google Scholar 

  5. J. Diao, B. Xie, Y.H. Wang, and X. Guo, Recovery of phosphorus from dephosphorization slag produced by duplex high phosphorus hot metal refining, ISIJ Int., 52(2012), No. 6, p. 955.

    Article  Google Scholar 

  6. J.D. Zhou, X.G. Bi, and F. Yang, Experimental study on phosphorus distribution between CaO-FeO*-SiO2-P2O5(15%)-CaF2 slag and carbon-saturated hot metal at 1573.15 K, Ironmaking Steelmaking, 41(2014), No. 4, p. 298.

    Article  Google Scholar 

  7. S. Basu, A.K. Lahiri, S. Seetharaman, S. Seetharaman, and J. Halder, Change in phosphorus partition during blowing in a commercial BOF, ISIJ Int., 47(2007), No. 5, p. 766.

    Article  Google Scholar 

  8. S.K. Choudhary, S.N. Lenka, and A. Ghosh, Assessment and application of equilibrium slag-metal phosphorous partition for basic oxygen steelmaking, Ironmaking Steelmaking, 34(2007), No. 4, p. 343.

    Article  Google Scholar 

  9. S.S. Zheng, W.H. Chen, J. Cai, J.T. Li, C. Chen, and X.T. Luo, Mass transfer of phosphorus in silicon melts under vacuum induction refining, Metall. Mater. Trans. B, 41(2010), No. 6, p. 1268.

    Article  Google Scholar 

  10. X. Zhang, B. Xie, H.Y. Li, J. Diao, and C.Q. Ji, Coupled reaction kinetics of duplex steelmaking process for high phosphorus hot metal, Ironmaking Steelmaking, 40(2013), No. 4, p. 282.

    Article  Google Scholar 

  11. C.P. Manning and R.J. Fruehan, The rate of the phosphorous reaction between liquid iron and slag, Metall. Mater. Trans. B, 44(2013), No. 1, p. 37.

    Article  Google Scholar 

  12. P. Wei, M. Sano, M. Hirasawa, and K. Mori, Kinetics of phosphorus transfer between iron oxide containing slag and molten iron of high carbon concentration under Ar-O2 atmosphere, ISIJ Int., 33(1993), No. 4, p. 479.

    Article  Google Scholar 

  13. A.N. Conejo, F.R. Lara, M. Macias-Hernández, and R.D. Morales, Kinetic model of steel refining in a ladle furnace, Steel Res. Int., 78(2007), No. 2, p. 141.

    Google Scholar 

  14. Z.H. Tian, Technology and Theory of Molten Steel Deep Dephosphorization out of Converter for Production of Ultra-low Phosphorus Steel [Dissertation], University of Science and Technology Beijing, Beijing, 2005, p. 141.

    Google Scholar 

  15. K. Mori, S. Doi, T. Kaneko, and Y. Kawai, Rate transfer of phosphorus between metal and slag, Trans. Iron Steel Inst. Jpn., 18(1978), No. 5, p. 261.

    Google Scholar 

  16. C.P. Manning, Behavior of Phosphorus in DRI/HBI during Electric Furnace Steelmaking [Dissertation], Carnegie Mellon University, Pittsburgh, 2000, p. 175.

    Google Scholar 

Download references

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Jiang Diao.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Diao, J., Liu, X., Zhang, T. et al. Mass transfer of phosphorus in high-phosphorus hot-metal refining. Int J Miner Metall Mater 22, 249–253 (2015). https://doi.org/10.1007/s12613-015-1068-0

Download citation

  • Received:

  • Revised:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s12613-015-1068-0

Keywords

Navigation