Abstract
The purpose of the present study was to investigate the effects of oil diluted by post-injected fuel for CDPF regeneration on engine wear and to find out the characteristic variation of diluted oil according to operating conditions. Experimental studies were made on a 2700 cc, 5 cylinder engine with an after-treatment system. Fuel content in oil increased according to the increase in the duration of post injection. A fuel dilution chart was made to predict the existing fuel content in used oil. The oil analysis method using this chart was validated through the comparison of the results analyzed by GC. The oil contamination by the post-injected fuel caused the quantity of blow-by gas and engine wear to increase and main gallery pressure to decrease.
Similar content being viewed by others
References
R. Allansson, P. G. Blakeman, B. J. Cooper, H. Hess, P. J. Silcock and A. P. Walker, Optimizing the Low Temperature Performance and Regeneration Efficiency of the Continuously Regenerating Diesel Particulate Filter, SAE 2002-01-0428, (2002).
P. Richards and W. Kalischewsk, Retrofitting of Diesel Particulate Filters — Particulate Matter and Nitrogen Dioxide, SAE 2003-01-1883, (2003).
C. S. Sluder and B. H. West, Catalyzed Diesel Particulate Filter Performance in a Light-Duty Vehicle, SAE 2000-01-2848, (2000).
P. J. Shayler, L. D. Winborn and A. Scarisbrick, The Build-Up of Oil Dilution by Gasoline and the Influence of Vehicle Usage Pattern, SAE 2000-01-2838, (2000).
T. Alger, Y. Huang, M. Hall and R. D. Matthews, Liquid Film Evaporation Off the Piston of a Direct Injection Gasoline Engine, SAE2001-01-1024, (2001).
T. Sagawa, H. Fujimoto and K. Nakamura, Study of Fuel Dilution in Direct-Injection and Multipoint Injection Gasoline Engines, SAE2002-01-1647, (2002).
Author information
Authors and Affiliations
Corresponding author
Additional information
This paper was recommended for publication in revised form by Associate Editor Kyoung Doug Min
Bong-Ha Song received a B.S. degree in Mechanical Engineering from Konkuk University in 1999. He received a M.S. degree from Yonsei University in 2002. He then went to Ajou University to get a Ph.D degree. Bong-Ha Song is currently a student at the School of Mechanical Engineering at Ajou University in Suwon, Korea.
Yun-Ho Choi received a B.S. degree in Mechanical Engineering from Seoul National University in 1978. He then went on to receive his M.S. and Ph.D. degrees from Pennsylvania State University in 1984 and 1988, respectively. Dr. Choi is currently a professor at the Division of Mechanical Engineering at Ajou University in Suwon, Korea. Dr. Choi’s research interests are in the area of Computational Fluid Dynamics, Thermal Propulsion Systems Modeling and Two Phase Flows.
Rights and permissions
About this article
Cite this article
Song, BH., Choi, YH. Investigation of variations of lubricating oil diluted by post-injected fuel for the regeneration of CDPF and its effects on engine wear. J Mech Sci Technol 22, 2526–2533 (2008). https://doi.org/10.1007/s12206-008-0903-x
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12206-008-0903-x