Erratum to: JOM, Vol. 68, No. 3, 2016 DOI: 10.1007/s11837-015-1810-0
-
There was an error in the caption to Fig. 4. The correct caption appears below.
Fig. 4 Examples of parts/components made by Powder Bed Fusion AM technologies. (a) Inlet temperature sensor housing for jet turbine engine, roughly 7.5 cm tall; (b) Ti-6Al-4V acetabular cup produced by electron beam melting, EBM (i.e., Arcam); (c) Bracket produced via laser-based powder bed (i.e., EOS); (d) GE LEAP engine Co-Cr fuel nozzle produced via direct metal laser melting, DMLM (i.e., EOS).
-
Some unit measures were incorrect in Fig. 5b. The corrected Fig. 5 appears below.
-
Also, the callout to Fig. 9a on page 757 should refer to Fig. 9a (left).
Author information
Authors and Affiliations
Corresponding author
Additional information
The online version of the original article can be found under doi:10.1007/s11837-015-1810-0.
Rights and permissions
About this article
Cite this article
Seifi, M., Salem, A., Beuth, J. et al. Erratum to: Overview of Materials Qualification Needs for Metal Additive Manufacturing. JOM 68, 1492 (2016). https://doi.org/10.1007/s11837-016-1901-6
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11837-016-1901-6