Abstract
The hydrodynamics in microcavities populated with cylindrical micropins was investigated using dynamic pressure measurements and fluid pathline visualization. Pressure signals were Fourier-analyzed to extract the flow fluctuation frequencies, which were in the kHz range for the tested flow Reynolds numbers (Re) of up to 435. Three different sets of flow dependent characteristic frequencies were identified, the first due to vortex shedding, the second due to lateral flow oscillation and the third due to a transition between these two flow regimes. These frequencies were measured at different locations along the chip (e.g. inlet, middle and outlet). It is established that vortex shedding initiates at the outlet and then travels upstream with increase in Re. The pathline visualization technique provided direct optical access to the flow field without any intermediate post-processing step and could be used to interpret the frequencies determined through pressure measurements. Microcavities with different micropin height-to-diameter aspect ratios and pitch-to-diameter ratios were tested. The tests confirmed an increase in the Strouhal number (associated with the vortex shedding) with increased confinement (decrease in the aspect ratio or the pitch), in agreement with macroscale measurements. The compact nature of the microscale geometry tested, and the measurement technique demonstrated, readily enabled us to investigate the flow past 4,420 pins with various degrees of confinements; this makes the measurements performed and the techniques developed here an important tool for investigating large arrays of similar objects in a flow field.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Alfieri F, Tiwari MK, Zinovik I, Brunschwiler T, Michel B, Poulikakos D (2012) On the significance of developing boundary layers in integrated water cooled 3D chip stacks. Int J Heat Mass Tran 55:5222–5232. doi:10.1016/j.ijheatmasstransfer.2012.05.029
Brunschwiler T, Michel B, Rothuizen H, Kloter U, Wunderle B, Oppermann H, Reichl H (2009) Interlayer cooling potential in vertically integrated packages. Microsyst Technol 15:57–74. doi:10.1007/s00542-008-0690-4
Chung YC, Hsu YL, Jen CP, Lu MC, Lin YC (2004) Design of passive mixers utilizing microfluidic self-circulation in the mixing chamber. Lab Chip 4:70–77. doi:10.1039/B310848c
Dang B, Bakir MS, Sekar DC, King CR, Meindl JD (2010) Integrated microfluidic cooling and interconnects for 2D and 3D chips. IEEE Trans Adv Packag 33:79–87. doi:10.1109/Tadvp.2009.2035999
Davis RW, Moore EF, Purtell LP (1984) A numerical-experimental study of confined flow around rectangular cylinders. Phys Fluids 27:46–59. doi:10.1063/1.864486
Groisman A, Enzelberger M, Quake SR (2003) Microfluidic memory and control devices. Science 300:955–958. doi:10.1126/science.1083694
Gunther A, Jensen KF (2006) Multiphase microfluidics: from flow characteristics to chemical and materials synthesis. Lab Chip 6:1487–1503. doi:10.1039/B609851G
Hoffmann M, Schluter M, Rabiger N (2006) Experimental investigation of liquid–liquid mixing in T-shaped micro-mixers using μ-LIF and μ-PIV. Chem Eng Sci 61:2968–2976. doi:10.1016/j.ces.2005.11.029
Konstantinidis E, Balabani S, Yianneskis M (2002) A study of vortex shedding in a staggered tube array for steady and pulsating cross-flow. J Fluid Eng-T ASME 124:737–746. doi:10.1115/1.1487359
Kumar B, Kottaram JJ, Singh AK, Mittal S (2009) Global stability of flow past a cylinder with centreline symmetry. J Fluid Mech 632:273–300. doi:10.1017/S0022112009007241
Moghtaderi B (2007) Effect of enhanced mixing on partial oxidation of methane in a novel micro-reactor. Fuel 86:469–476. doi:10.1016/j.fuel.2006.08.009
Monkewitz PA, Nguyen LN (1987) Absolute instability in the near-wake of two-dimensional bluff bodies. J Fluid Struct 1:165–184. doi:10.1016/S0889-9746(87)90323-9
Nabavi M (2009) Steady and unsteady flow analysis in microdiffusers and micropumps: a critical review. Microfluid Nanofluid 7:599–619. doi:10.1007/s10404-009-0474-x
Natrajan VK, Christensen KT (2010) The impact of surface roughness on flow through a rectangular microchannel from the laminar to turbulent regimes. Microfluid Nanofluid 9:95–121. doi:10.1007/s10404-009-0526-2
Osman O, Shintaku H, Kawano S (2012) Development of micro-vibrating flow pumps using MEMS technologies. Microfluid Nanofluid 13:703–713. doi:10.1007/s10404-012-0988-5
Owen PR (1965) Buffeting Excitation of Boiler Tube Vibration. J Mech Eng Sci 7:431–439. doi:10.1243/jmes_jour_1965_007_065_02
Patil PP, Tiwari S (2010) Three-dimensional numerical investigations on flow and heat transfer for flow past a channel confined square cylinder. Prog Comput Fluid Dy 10:146–156. doi:10.1504/PCFD.2010.033326
Polak DR, Weaver DS (1995) Vortex shedding in normal triangular tube arrays. J Fluid Struct 9:1–17. doi:10.1006/jfls.1995.1001
Prasad A, Williamson CHK (1997) The instability of the shear layer separating from a bluff body. J Fluid Mech 333:375–402. doi:10.1017/S0022112096004326
Renfer A, Tiwari MK, Brunschwiler T, Michel B, Poulikakos D (2011) Experimental investigation into vortex structure and pressure drop across microcavities in 3D integrated electronics. Exp Fluids 51:731–741. doi:10.1007/s00348-011-1091-5
Rossi M, Lindken R, Hierck BP, Westerweel J (2009) Tapered microfluidic chip for the study of biochemical and mechanical response at subcellular level of endothelial cells to shear flow. Lab Chip 9:1403–1411. doi:10.1039/B822270n
Sen D, Nobes DS, Mitra SK (2012) Optical measurement of pore scale velocity field inside microporous media. Microfluid Nanofluid 12:189–200. doi:10.1007/s10404-011-0862-x
Stroock AD, Dertinger SKW, Ajdari A, Mezic I, Stone HA, Whitesides GM (2002) Chaotic mixer for microchannels. Science 295:647–651. doi:10.1126/science.1066238
Sweeney C, Meskell C (2003) Fast numerical simulation of vortex shedding in tube arrays using a discrete vortex method. J Fluid Struct 18:501–512. doi:10.1016/j.jfluidstructs.2003.08.009
Turki S, Abbassi H, Nasrallah SB (2003) Effect of the blockage ratio on the flow in a channel with a built-in square cylinder. Comput Mech 33:22–29. doi:10.1007/s00466-003-0496-2
Weaver DS, Fitzpatrick JA, Elkashlan M (1987) Strouhal numbers for heat-exchanger tube arrays in cross flow. J Press Vess-T ASME 109:219–223
Ziada S (2006) Vorticity shedding and acoustic resonance in tube bundles. J Braz Soc Mech Sci & Eng 28:186–189
Ziada S, Oengören A (1992) Vorticity shedding and acoustic-resonance in an in-line tube bundle part 1: vorticity shedding. J Fluid Struct 6:271–292. doi:10.1016/0889-9746(92)90010-Z
Ziada S, Oengören A (2000) Flow periodicity and acoustic resonance in parallel triangle tube bundles. J Fluid Struct 14:197–219. doi:10.1006/jfls.1999.0259
Acknowledgments
This work was partially supported by the Swiss Confederation through the SNSF administered RTD project nr. 618_67-CMOSAIC-funded by Nano-Tera.ch. The support is gratefully acknowledged. AR and MKT also acknowledge the fruitful discussions with Mr. Ashish Asthana and Mr. Fabio Alfieri of LTNT, ETH Zurich.
Author information
Authors and Affiliations
Corresponding author
Electronic supplementary material
Below is the link to the electronic supplementary material.
Rights and permissions
About this article
Cite this article
Renfer, A., Tiwari, M.K., Meyer, F. et al. Vortex shedding from confined micropin arrays. Microfluid Nanofluid 15, 231–242 (2013). https://doi.org/10.1007/s10404-013-1137-5
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10404-013-1137-5