Abstract
Aluminum films were prepared on H2-plasma pretreated TiN substrates at deposition temperatures of 60-250 °C by metallorganic chemical vapor deposition using dimethylethylamine alane as a precursor. The films were highly pure and the growth rates were 3-50 nm/min, where the lowest deposition temperature was 60 °C. The resistivity was as low as 2.8 μΩcm. High substrate temperatures tended to favor a low resistivity and smooth surface morphology of the films, compared to films with a low temperature at a given thickness. Numerous empty pores appeared in the Al films deposited at a temperature below 150 °C when the film thickness exceeded 200 nm. The number of these pores tended to increase with decrease in temperature. However, in films deposited at temperatures above 200 °C, there were no pores and the large grains were interconnected to a high degree. Higher deposition temperatures yielded a greater preference of the (111) orientation of Al films.
Similar content being viewed by others
References
Amazawa, T., “Selective Chemical Vapor Deposition of Smooth Aluminum Films from Highly Supersaturated Source Gas,”J. Electrochem. Soc.,146, 4111 (1999).
Gladfelter, W. L., Boyd, D. C. and Jensen, K. F., “Trimethylamine Complexes of Alane as Precursors for the Low Pressure Chemical Vapor Deposition of Aluminum,”Chem. Mater.,1, 339(1989).
Green, M. L. and Gallagher, P.K., “LPCVD Aluminum for VLSI Processing,”J. Electrochem. Soc.,131, 2175 (1984).
Gross, M. E., Fleming, C. G., Cheung, K. P. and Heimbrook, L. A., “Liquid Source Metalorganic Chemical Vapor Deposition of Aluminum using Triethylamine Alane,”Appl. Phys. Lett.,69, 2589 (1991).
Jang, J.W., Rhee, H. S. and Ahn, B. T., “Hydrogen Plasma Pretreatment Effect on the Deposition of Aluminum Thin Films from Metalorganic Chemical Vapor Deposition using Dimethylethylamine Alane,”J. Vac. Sci. Technol.,A17, 1031 (1999).
Jonnalagadda, R., Yang, D., Rogers, B. R., Hillman, J. T., Foster, R. F. and Cale, T. S., “Programmed Substrate Temperature Ramping to Increase Nucleation Density and Decrease Surface Roughness during Metalorganic Chemical Vapor Deposition of Aluminum,”J. Mat. Res.,14, 1982 (1999).
Kim, B.-Y., Li, X. and Rhee, S.-W., “Microstructure and Deposition Rate of Aluminum Thin Films from Chemical Vapor Deposition with Dimethylethylamine Alane,”Appl. Phys. Lett.,67, 3426 (1995).
Kondo, E. and Ohta, T., “Chemical Vapor Deposition of Aluminum from Dimethylaluminumhydride (DMAH): Characteristics of DMAH Vaporization and Al Growth Kinetics,”J. Vac. Sci. Technol.,A13, 2863 (1995).
Lee, K.-I., Kim, Y.-S. and Joo, S.-K., “Effect of Substrate Temperature on the Selectivity in Low Pressure Chemical Vapor Deposition of Aluminum,”J. Electrochem. Soc.,139, 3578 (1992).
Masu, K., Tsubouchi, K., Shigeeda, N., Matano, T. and Mikoshiba, N., “Selective Deposition of Aluminum from Selectively Excited Metalorganic Source by the RF Plasma,”Appl. Phys. Lett.,56, 1543 (1990).
Murarka, S. P., “Metallization: Theory and Practice for ULSI and VLSI,” Butterworth-Heinemann, Stoneham (1992).
Naik, M., Guo, T., Chen, L., Mosely, R. and Beinglass, I., “Texture and Surface Morphology Improvement of Al by Two-stage Chemical Vapor Deposition and its Integration in an Al-plug-interconnect Scheme for sub 0.25 μm Metallization,”J. Vac. Sci. Technol.,A16, 1233 (1998). Simmonds, M. G., Gladfelter, W. L., Nagara, R., Szymanski, W. N.,
Ahn, K. H. and McMurry, P. H., “Particle Contamination in Low Pressure Organometallic Chemical Vapor Deposition Reactor: Methods of Particle Detection and Causes of Particle Formation using a Liquid Alane (AlH3) Precursor,”J. Vac. Sci. Technol.,A9, 2782 (1991).
Simmonds, M. G., Taupin, I. and Gladfelter, W. L., “Selective Area Chemical Vapor Deposition of Aluminum using Dimethylethylamine Alane,”Chem. Mater.,6, 935 (1994).
Sugai, K., Kishida, S., Shinzawa, T., Okabayashi, H., Yako, T., Kadokura, H., Isemura, M., Kobayashi, A. and Hosokawa, N., “Aluminum Metallization using a Combination of Chemical Vapor Deposition and Sputtering,”J. Electrochem. Soc.,144, 1028 (1997).
Sugai, K., Okabayashi, H., Shinzawa, T., Kishida, S., Kobayashi, A., Yako, T. and Kadokura, H., “Aluminum Chemical Vapor Deposition with New Gas Phase Treatment using Tetrakis-dimethylaminotitanium for Ultralarge-scale Integrated Circuit Metallization,”J. Vac. Sci. Technol.,B13, 2115 (1995).
Yun, J.-H., Kim, B.-Y. and Rhee, S.-W., “Metal-organic Chemical Vapor Deposition of Aluminum from Dimethylethylamine Alane,”Thin Solid Films,312, 259 (1998).
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Kim, DH., Kim, BY. Characteristics of aluminum films prepared by metalorganic chemical vapor deposition using dimethylethylamine alane on the plasma-pretreated TiN surfaces. Korean J. Chem. Eng. 17, 449–454 (2000). https://doi.org/10.1007/BF02706859
Received:
Accepted:
Issue Date:
DOI: https://doi.org/10.1007/BF02706859