Distribution & Access For Publication Downloads News About Us Contact Us
Paper Titles
Effect of the Surface Morphology of Zinc Oxide Particles on their Radiation Stability
p.338
Protective Coatings Formed by PEO and Fluorine-Containing Compound
p.343
Manganese-Containing Nanostructured Oxide Coatings on Titanium Formed by Plasma Electrolytic Oxidation
p.349
Analysis of the TiO2 Nanotubes Structure Ordering in the Correlation-Spectral Representation
p.353
High-Capacity Derivatives Produced from Hydrolytic Lignin as Electrode Materials for Energy Storage and Conversion
p.359
Sol-Gel Synthesis of Novel Siliconorganic Sulfur-Containing Sorption Materials
p.365
Fabrication of Nanostructured Gradient Tungsten-Cobalt Alloy Using Carbon Deficiency Powder
p.370
Atomic Ordering and Disordering of Amorphous CoNiP Alloy
p.377
Computer Simulation of Plastic Deformation in Tial Alloys in the Presence of Chromium
p.383

High-Capacity Derivatives Produced from Hydrolytic Lignin as Electrode Materials for Energy Storage and Conversion

Article Preview

Abstract:

The hydrolytic lignin derivatives have been prepared via its physical activation (high-temperature heating in vacuum) followed by chemical modification (fluorination). The obtained products were characterized using scanning electron microscopy, X-ray diffraction, transmission electron microscopy, Raman spectroscopy, and X-ray photoelectron spectroscopy. It was found that the graphitized product of thermal activation up to 1000 °C at a low rate of < 2 °C/min under high vacuum shows an enhanced specific surface area (215 m2/g), that makes its potentially useful as sorbent, catalytic substrate or electrode material. To clarify the potentialities of hydrolytic lignin derivatives for energy storage and conversion, the electrochemical system with metallic lithium anode was applied. The galvanostatic discharge of battery at a current density of 100 μA/cm2 between 3.0 and 0.5 V shows that the specific capacity of thermally activated derivative is equal to 845 mA·h/g, while the untreated lignin yields only 190 mA·h/g. The improve of the electrochemical performance of product originates from its graphitization, increasing electronic conductivity, and, possibly, enhanced ability to adsorb of oxygen. The fluorination of both the lignin and its thermally activated form results in higher operating voltage of battery, as seems, due to the involvement of fluorine bound to carbon in electrochemical process.

You might also be interested in these eBooks
Physics and Technology of Nanostructured Materials IV View Preview

Info:

Periodical:

Defect and Diffusion Forum (Volume 386)

Pages:

359-364

DOI:

https://doi.org/10.4028/www.scientific.net/DDF.386.359

Citation:

Cite this paper

Online since:

September 2018

Authors:

Yury M. Nikolenko*, Denis P. Opra, Alexander K. Tsvetnikov, Alexander Yu. Ustinov, Valery G. Kuryavyi, Alexander A. Sokolov, Vladimir E. Silant'ev, Grigorii A. Zverev, Vitalyi Yu. Majorov, Sergey L. Sinebryukhov, Sergey V. Gnedenkov

Keywords:

Fluorinated Lignin, Hydrolytic Lignin Derivative, Lithium Battery, Organic Electrode, XPS

Export:

RIS, BibTeX

Price:

Permissions:

Request Permissions

* - Corresponding Author

References

[1] K.E. Aifantis, S.A. Hackney, R.V. Kumar, High energy density lithium batteries: Materials, engineering, applications, Wiley‐VCH Verlag GmbH & Co. KGaA, Weinheim, (2009).

Google Scholar

[2] D. Linden, T.B. Reddy, Handbook of batteries, McGraw-hill, New York, (2002).

Google Scholar

[3] T. Nakajima, Fluorine-carbon and fluoride-carbon materials: Chemistry, physics, and applications, CRC Press, Boca Raton, Florida, (1994).

Google Scholar

[4] J. Liu, Charging graphene for energy, Nature Nanotechnology. 9 (2014) 739-741.

Google Scholar

[5] J. Liu, Y. Xue, M. Zhang, L. Dai, Graphene-based materials for energy applications, MRS Bulletin, 37 (2012) 1265-1272.

DOI: 10.1557/mrs.2012.179

Google Scholar

[6] L.A.M. Nevarez, L.B. Casarrubias, A. Celzard, V. Fierro, V.T. Munoz, A.C. Davila, J.R.T. Lubian, G.G. Sanchez. Sci. Technol. Adv. Mater.12 (2011) 1-16.

Google Scholar

[7] J.M.. Rosas, R. Berenruer, M. J. Valero-Romero, J. Rodriguez-Mirasol and T. Cordero, Frontiers in Materials | Carbon-Based Materials. 1 (2014) 1-17. Information on www.frontiersin.org.

Google Scholar

[8] S.V. Gnedenkov, D.P. Opra, S.L. Sinebryukhov, A.K. Tsvetnikov, A.Yu. Ustinov, V.I. Sergienko, Hydrolysis lignin-based organic electrode material for primary lithium batteries, J. Solid State Electrochem. 17 (2013) 2611-2621.

DOI: 10.1007/s10008-013-2136-x

Google Scholar

[9] G. Milczarek, O. Inganäs, Renewable cathode materials from biopolymer/conjugated polymer interpenetrating networks, Science 335 (2012) 1468-1471.

DOI: 10.1126/science.1215159

Google Scholar

[10] M. Kijima, T. Hirukawa, F. Hanawa, T. Hata, Thermal conversion of alkaline lignin and its structured derivatives to porous carbonized materials, Bioresource Technology. 102 (2011) 6279-6285.

DOI: 10.1016/j.biortech.2011.03.023

Google Scholar

[11] Yu.M. Nikolenko and A.M. Ziatdinov, Nanographite Films: Structure and Properties, Solid St. Phenomena, 247 (2016) 17-23.

DOI: 10.4028/www.scientific.net/ssp.247.17

Google Scholar

[12] S.S. Bukalov, L.A. Mikhalitzin, Ua.V. Zubavitchus., L.A. Leytes., Yu.N. Novikov, Investigation of the Structure of Graphite and Other sp2 Carbon Materials by Raman Microscopy and X-ray Diffraction, Ross. Khim. Zh. (Zh. Ross. Khim. O-va im D.I. Mendeleeva) I (2006).

Google Scholar

[13] T. Jawhari, A. Roid and J. Casado, Raman spectroscopic characterization of some commercially available carbon black materials, Carbon. 33 (1995) 1561-1565.

DOI: 10.1016/0008-6223(95)00117-v

Google Scholar

[14] A.C. Ferrari and J. Robertson, Interpretation of Raman spectra of disordered and amorphous carbon, Phys. Rev. B. 61 (2000) 14095-14107.

DOI: 10.1103/physrevb.61.14095

Google Scholar

[15] F. Tuinstra, J.L. Koenig, Raman Spectrum of Graphite, J. Phys. Chem. 53 (1970) 1126–1130.

Google Scholar

[16] L. G. Cançado, K. Takai, T. Enoki, M. Endo, Y. A. Kim, H. Mizusaki, A. Jorio, L. N. Coelho, R. Magalhães-Paniago, M. A. Pimenta, General equation for the determination of the crystallite size La of nanographite by Raman spectroscopy, Applied Phys. Let. 88 (2006).

DOI: 10.1063/1.2196057

Google Scholar

[17] E.J. Yoo, J. Kim, E. Hosono, H. Zhou, T. Kudo, I. Honma, Nanao Letters, 8 (2008) 2277-2282.

Google Scholar

[18] L. Zhao, W. Wang, A. Wang, K. Yuan, S. Chen, Y. Yang, J. Power Sources. 233 (2013) 23-27.

Google Scholar

[19] W.A. Schalkwijk, B. Scrosati, Advances in lithium-ion batteries, Springer science+business media, Berlin, (2002).

Google Scholar

[20] B. Scrosati, J. Garche. J. of Power Sources 195 (2010) 2419-2430.

Google Scholar

Scientific.Net is a registered brand of Trans Tech Publications Ltd
© 2024 by Trans Tech Publications Ltd. All Rights Reserved