A Study on the Design Curves for Pultruded Composite Columns

Seung Sik Lee; Soo Ha Chae; Soon Jong Yoon; Sun Kyu Cho

doi:10.4028/www.scientific.net/AMR.26-28.337

Paper Titles

Fabrication of Oxide Ceramics Composite by Reactive Infiltration Process
p.321

Effect of Powder Blending Ratio on Synthesis of TiB₂ Particles by Al-Ti-B Combustion Reaction
p.325

Development of Hybrid FRP-Concrete Composite Compression Members
p.329

Effect of Phosphorus Doping into the Silicon as an Anode Material for Lithium Secondary Batteries
p.333

A Study on the Design Curves for Pultruded Composite Columns
p.337

Structural Behavior of Polymer Mortar GFRP Composite Pipe
p.341

Physical Characteristic of Ready Mixed Concrete with Different Replacement Ratio of Recycled Aggregate
p.345

Evaluation of the Influence of Additives on the Mechanical Properties and Photo-Stability of Glass Fiber Reinforced Epoxy Pipes Using Central Composite Design
p.349

Microstructure, Hardness, and Wear Resistance of Powder-Injection-Molded Products of Fe-Based Metamorphic Powders
p.355

HomeAdvanced Materials ResearchAdvanced Materials Research Vols. 26-28A Study on the Design Curves for Pultruded...

A Study on the Design Curves for Pultruded Composite Columns

Abstract:

The strengths of PFRP thin-walled columns are determined according to the modes of buckling which consist of local mode for short columns, global mode for long columns, and interaction mode between local and global modes for intermediate columns. Unlike the local and global buckling, the buckling strength of interaction mode is not theoretically predictable. Refined theoretical approaches which can account for different elastic properties of each plate component consisting of a PFRP thin-walled member are used. Based on both the analytical buckling loads and the experimentally measured buckling loads from literatures, the accuracies of Ylinen’s equation and modified AISC/LRFD column design equation for isotropic steel columns were compared. From the comparison, it was found that the modified AISC/LRFD column design equation is more suitable for the prediction of the buckling loads of PFRP thin-walled members than Ylinen’s equations.