An Experimental Study on the Performance and Emissions of Diesel Engine Fuelled with Biodiesel Derived from Palm Oil

Article Preview

Abstract:

The use of biodiesel as an alternative fuels in the diesel engine is very effective due to less of emissions and high performance. This study investigated the effect of palm oil blending and engine speed on performance and emission in diesel engine. The performance of biodiesel blends were investigated in terms of brake power, fuel consumption rate, flywheel torque, while emissions parameter was tested in terms of smoke opacity, hydrocarbon (HC), nitrogen oxide (NOx), carbon oxide (CO), carbon dioxide (CO2) and oxygen (O2) at various engine speed 1500, 2000, 2500 and 3000 revolution per minute (rpm). Biodiesel was blended with ordinary diesel fuel in various proportions. The engine was tested up to 50% load conditions by using Ordinary Diesel (OD), B5, B10 and B15 fuels. The properties of biodiesel fuel were tested including density, kinematic viscosity, water content and flash points test. Experimental results indicated that biodiesel blend shows the flywheel torque obtained is higher compared to the OD but fuel consumption rate and the brake power are quite similar when tested at ambient temperature. All biodiesel blends released good emissions compared to the OD. The CO2, CO, HC and O2 content released from the biodiesel fuels were clearly lower than the normal fuel except for NOX contents. Biodiesel released higher smoke opacity compared to OD at all range of engine speeds under 50% load condition. In conclusion, biodiesel fuels are found to offer better performances and emissions and are suitable to be used in unmodified diesel engine.

You might also be interested in these eBooks

Info:

Periodical:

Pages:

654-659

Citation:

Online since:

November 2014

Export:

Price:

[1] S. Park, H. Kim, and B. Choi, Emission characteristics of exhaust gases and nanoparticles from a diesel engine with biodiesel-diesel blended fuel (BD20), Journal of Mechanical Science and Technology, (2009) 2555-2564.

DOI: 10.1007/s12206-009-0704-x

Google Scholar

[2] D. Tziourtzioumis, et al., Experimental investigation of the effect of a B70 biodiesel blend on a common-rail passenger car diesel engine, Proc. IMechE, 223 (2008) 685-701.

DOI: 10.1243/09544070jauto1094

Google Scholar

[3] A. Senatore, et al., A comparative analysis of combustion process in D.I. diesel engine fueled with biodiesel and diesel fuel, SAE Technical Paper 2000-01-0691, (2000).

DOI: 10.4271/2000-01-0691

Google Scholar

[4] J. T. Song, and C.H. Zhang, An experimental study on performance and exhaust emissions of a diesel engine fuelled with soybean oil methyl ester, Proc IMechE Part D: J Automob Eng, 222 (2008) 2487-2496.

DOI: 10.1243/09544070jauto932

Google Scholar

[5] A. Khalid, et al., Performance and emissions characteristics of diesel engine fuelled by biodiesel derived from palm oil. Applied Mechanics and Materials, 315 (2013) 517-522.

DOI: 10.4028/www.scientific.net/amm.315.517

Google Scholar

[6] M. K. Veltman, P.K. Karra, and S. -C. Kong, Effects of biodiesel blends on emissions in low temperature diesel combustion. SAE Paper 2009-01-0485, (2009).

DOI: 10.4271/2009-01-0485

Google Scholar

[7] S. Alfuso, M. Auriemma, G. Police, and M. Prati, The effect of methyl-ester of rapeseed oil on combustion and emissions of di diesel engines, SAE Technical Paper 932801 (1993).

DOI: 10.4271/932801

Google Scholar

[8] R. Anand, G. Kannan, S. Nagarajan, and S. Velmathi, Performance emission and combustion characteristics of a diesel engine fueled with biodiesel produced from waste cooking oil, SAE Technical Paper 2010-01-0478 (2010).

DOI: 10.4271/2010-01-0478

Google Scholar

[9] A. Khalid, et al., Analysis of relation between mixture formation during ignition delay period and burning process in diesel combustion. SAE Technical Paper, (2009) 1-10.

Google Scholar

[10] El-Awad, M.M. and T.F. Yusaf, Performance and exhaust emission of a diesel engine using crude palm oil as fuel extender. Journal of Energy and Environment, 3 (2004) 61-68.

Google Scholar

[11] A. Khalid, and B. Manshoor, Analysis of mixture formation and flame development of diesel combustion using a rapid compression machine and optical visualization technique. Applied Mechanics and Materials, 315 (2013) 293-298.

DOI: 10.4028/www.scientific.net/amm.315.293

Google Scholar