Skip to main content
Log in

Study of the Pull-In Voltage for MEMS Parallel Plate Capacitor Actuators

  • Articles
  • Published:
MRS Online Proceedings Library Aims and scope

Abstract

This paper provides new investigation for the static and dynamic behavior of a MEMS parallel plate capacitor derived by analytical and numerical design modeling programs developed in Matlab. One significant finding is about the role, which has so far overlooked in many analyses, of a dielectric layer normally placed on top of the ground electrode to avoid short circuiting risks. It is demonstrated in this paper that this layer produces an increased force between electrodes that in turns decreases the well-known pull-in voltage, Vpi, as compared to the one calculated when this dielectric layer is not considered on the system’s static analysis. Expressions for the static Vpi and its corresponding maximum stable electrode swing xpi are derived to take the above effect into account.

The system dynamic analysis is done with a user-friendly Simulink interface constructed to allow easy introduction of capacitor design dimensions, material parameter values and voltage signal stimuli. The impact of any combination of these parameters on the electro-mechanical system behavior, that is, the voltage-electrode position dependence data can be easily extracted and become of help for design decision making on the early design stages of this type of structures. This modeling tool interface is based on solving the full differential equation that describes the free electrode displacement without relying on linearizing the inverse quadratic electrode separation dependence of the electro-static force term. This approach intrinsically takes into account the voltage dependant k-spring softening effect derived precisely from a linearizing simplification. Finally, by applying a saw-tooth voltage waveform, the dynamic pull-in voltage and the maximum stable electrode travel range are observed to go well beyond the predicted static pull-in voltage and travel range values.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Similar content being viewed by others

References

  1. Olivier Français, “Analysis of an Electrostatic Microactuator with the help of Matlab/simulink: transient and frequency characteristics”. MSM2000, San Diego, CA, USA, March 27–29, 2000, pp 281–284.

    Google Scholar 

  2. O. Solgaard, EE321 MEMS Design Course, Chapter 6 Non Linear Dynamics, April 2003. Standford University.

  3. David K. Cheng, Fundamentals of Engineering Electromagnetics Ch. 3, Adison-Wesley USA, 1993, ISBN 968 444 327.

Download references

Author information

Authors and Affiliations

Authors

Rights and permissions

Reprints and permissions

About this article

Cite this article

Saucedo-Flores, E., Ruelas, R., Flores, M. et al. Study of the Pull-In Voltage for MEMS Parallel Plate Capacitor Actuators. MRS Online Proceedings Library 782, 586 (2003). https://doi.org/10.1557/PROC-782-A5.86

Download citation

  • Published:

  • DOI: https://doi.org/10.1557/PROC-782-A5.86

Navigation