Skip to main content
Log in

Phase equilibria in the Sn-rich corner of the Sn–Cu–Ni ternary alloy system at 240 °C

  • Article
  • Published:
Journal of Materials Research Aims and scope Submit manuscript

Abstract

The interfacial reactions between solders and under bump metallization (UBM) have been of great interest recently in flip chip technology. Intermetallic compounds (IMCs), i.e., (Cu,Ni)6Sn5 and (Ni,Cu)3Sn4, usually formed between solders and UBM. To fully understand the interfacial reactions and phase transformation phenomenon, a suitable phase diagram concerning solders, IMCs, and UBM materials is required. In particular, a Sn-rich phase region in the Sn–Cu–Ni ternary diagram is very critical in determining the concentration tendency of x and y values in (Ni1−x,Cux)3Sn4 and (Cu1−y,Niy)6Sn5 compounds. In this study, ternary Sn–Cu–Ni alloys were prepared and annealed at 240 °C. Three equilibrium phases, Sn, Ni3Sn4, and Cu6Sn5, were identified by x-ray diffraction analysis and also showed in backscattered electron imaging. Using electron probe microanalysis quantitative analysis, three acme compositions of the ternary region in the Sn–Cu–Ni isotherm near the Sn-rich corner were determined as 98.5 at.% Sn, (Ni0.80, Cu0.20)3Sn4 and (Cu0.59,Ni0.41)6Sn5. In addition, the solubility of Cu and Ni in (Ni,Cu)3Sn4 and (Cu,Ni)6Sn5 compounds was evaluated. Finally, the isothermal section of the ternary Sn–Cu–Ni system at 240 °C was proposed on the basis of experimental results in this study.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Similar content being viewed by others

References

  1. J.H. Lau: Flip Chip Technologies (McGraw-Hill, New York, 1996), pp. 26–30.

    Google Scholar 

  2. T.Y. Lee, W.J. Choi, K.N. Tu, J.W. Jang, S.M. Kuo, J.K. Lin, D.R. Frear, K. Zeng and J.K. Kivilahti: Morphology, kinetics, and thermodynamics of solid-state aging of eutectic SnPb and Pb-free solders (Sn–3.5Ag, Sn–3.8Ag–0.7Cu and Sn–0.7Cu) on Cu. J. Mater. Res. 17, 291 (2002).

    Article  CAS  Google Scholar 

  3. C.S. Chang, A. Oscilowski and R.C. Bracken: Future challenges in electronics packaging. IEEE Circuits Dev. 14, 45 (1998).

    Article  Google Scholar 

  4. M.E. Loomans, S. Vaynman, G. Ghosh and M.E. Fine: Investigation of multicomponent lead-free solder. J. Electron. Mater. 23, 741 (1994).

    Article  CAS  Google Scholar 

  5. A.A. Liu, H.K. Kim, K.N. Tu and P.A. Totta: Spalling of Cu6Sn5 spheroids in the soldering reaction of eutectic SnPb on Cr/Cu/Au thin films. J. Appl. Phys. 80, 2774 (1996).

    Article  CAS  Google Scholar 

  6. K.L. Lin and Y.C. Liu: Manufacturing of Cu/electroless nickel/Sn–Pb flip chip solder bumps. IEEE Trans. Adv. Packag. 22, 575 (1999).

    CAS  Google Scholar 

  7. H.K. Kim, K.N. Tu and P.A. Totta: Ripening-assisted asymmetric spalling of Cu–Sn compound spheroids in solder joints on Si wafers. Appl. Phys. Lett. 68, 2204 (1996).

    Article  CAS  Google Scholar 

  8. C.A. Harper: Electronic Packaging and Interconnection Handbook, 3rd ed. (McGraw-Hill, New York, 2000), pp. 6.78–6.82.

    Google Scholar 

  9. M. Abtew and G. Selvaduray: Lead-free solders in microelectronics. Mater. Sci. Eng. R-Rep. 27, 95 (2001).

    Article  Google Scholar 

  10. J.W. Morris, J.L.F. Goldstein and Z. Mei: Microstructure and mechanical-properties of Sn–In and Sn–Bi Solders. JOM 45, 25 (1993).

    Article  CAS  Google Scholar 

  11. K. Zeng and K.N. Tu: Six cases of reliability study of Pb-free solder joints in electronic packaging technology. Mater. Sci. Eng. R-Rep. 38, 55 (2002).

    Article  Google Scholar 

  12. C.C. Young, J.G. Duh and S.Y. Tsai: Microstructural evoluation in the Sn–Cu–Ni and Pb–Sn solder joints with Cu and Pt–Ag metallized Al2O3 substrate. J. Electron. Mater. 30, 1241 (2001).

    Article  CAS  Google Scholar 

  13. Y.G. Lee and J.G. Duh: Interfacial morphology and concentration profile in the unleaded solder/Cu joint assembly. J. Mater. Sci. 10, 33 (1999).

    CAS  Google Scholar 

  14. Y.G. Lee and J.G. Duh: Phase analysis in the solder joint of Sn–Cu solder/IMC/Cu substrate. Mater. Charact. 42, 143 (1999).

    Article  CAS  Google Scholar 

  15. K. Zeng, V. Vuorinen and J.K. Kivilahti: Interfacial reactions between lead-free SnAgCu solder and Ni(P) surface finish on printed circuit boards. IEEE Trans. Electron. Packag. Manuf. 25, 162 (2002).

    Article  CAS  Google Scholar 

  16. J.Y. Tsai, Y.C. Hu, C.M. Tsai and C.R. Kao: A study on the reaction between cu and Sn3.5Ag solder doped with small amounts of Ni. J. Electron. Mater. 32, 1203 (2003).

    Article  CAS  Google Scholar 

  17. G. Ghosh: Interfacial microstructure and the kinetics of interfacial reaction in diffusion couples between Sn–Pb solder and Cu/Ni/Pd metallization. Acta Mater. 48, 3719 (2000).

    Article  CAS  Google Scholar 

  18. B.L. Young and J.G. Duh: Interfacial reaction and microstructural evolution for electroplated Ni and electroless Ni in the under bump metallurgy with 42Sn58Bi solder during annealing. J. Electron. Mater. 30, 878 (2001).

    Article  CAS  Google Scholar 

  19. S.K. Kang, R.S. Rai and S. Purushothaman: Interfacial reactions during soldering with lead-tin eutectic and lead (Pb)-free, tin-rich solders. J. Electron. Mater. 25, 1113 (1996).

    Article  CAS  Google Scholar 

  20. C.R. Lin, S.W. Chen and C.H. Wang: Phase equilibria and solidification properties of Sn–Cu–Ni alloys. J. Electron. Mater. 31, 907 (2002).

    Article  CAS  Google Scholar 

  21. C.S. Huang, J.G. Duh, Y.M. Chen and J.H. Wang: Effects of Ni thickness and reflow times on interfacial reactions between Ni/Cu under-bump metallization and eutectic Sn–Pb solder in flip-chip technology. J. Electron. Mater. 32, 89 (2003).

    Article  CAS  Google Scholar 

  22. C.S. Huang, J.H. Yeh, B.L. Young and J.G. Duh: Phenomena of electroless Ni–P and intermetallic-compound stripping and dissolving in Sn–Bi and Sn–Pb solder joints with Au/EN/Cu metallization. J. Electron. Mater. 31, 1230 (2002).

    Article  CAS  Google Scholar 

  23. C.S. Huang and J.G. Duh: Interface reactions and phase equilibrium between Ni/Cu under-bump metallization and eutectic SnPb flip-chip solder bumps. J. Mater. Res. 18, 935 (2003).

    Article  CAS  Google Scholar 

  24. G.Y. Jang, C.S. Huang, L.Y. Hsiao and J.G. Duh: Mechanism of interfacial reaction for Sn–Pb solder bump with Ni/Cu UBM in flip chip technology. J. Electron. Mater. 33, 1118 (2004).

    Article  CAS  Google Scholar 

  25. J.I. Goldstein, D.E. Newbury, P. Echlin, D.C. Joy, C.E. Lyman, E. Lifshin, L. Sawyer and J.R. Michael: Scanning Electron Microscopy and X-ray Microanalysis, 3rd ed. (Plenum Press, New York, 2003), pp. 391–420.

    Book  Google Scholar 

Download references

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Jenq-Gong Duh.

Rights and permissions

Reprints and permissions

About this article

Cite this article

Li, CY., Duh, JG. Phase equilibria in the Sn-rich corner of the Sn–Cu–Ni ternary alloy system at 240 °C. Journal of Materials Research 20, 3118–3124 (2005). https://doi.org/10.1557/JMR.2005.0391

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1557/JMR.2005.0391

Navigation