应用化学 ›› 2019, Vol. 36 ›› Issue (1): 83-90.DOI: 10.11944/j.issn.1000-0518.2019.01.180059

• 研究论文 • 上一篇    下一篇

锌镁铝类水滑石负载碘氧化铋的制备与表征

李佳祁a,付大友a*(),袁东b,徐菁b   

  1. 四川理工学院a化学工程学院
    b化学与环境工程学院 四川 自贡 643000
  • 收稿日期:2018-03-06 接受日期:2018-06-26 出版日期:2019-01-01 发布日期:2019-01-04
  • 通讯作者: 付大友
  • 基金资助:
    四川省科技厅(2013JY0081)四川理工学院研究生创新基金项目(y2018057)和绿色催化四川省高校重点实验室开放基金(LYJ1405)项目资助

Preparation and Characterization of ZnMgAl Hydrotalcite Supported BiOI

LI Jiaqia,FU Dayoua*(),YUAN Dongb,XU Jingb   

  1. aCollege of Chemical Engineering
    bCollege of Chemistry and Environmental Engineering,Sichuan University of Science and Engineering,Zigong,Sichuan 643000,China
  • Received:2018-03-06 Accepted:2018-06-26 Published:2019-01-01 Online:2019-01-04
  • Contact: FU Dayou
  • Supported by:
    Supported by the Science & Technology Department of Sichuan Province(No.2013JY0081), the Innovation Fund of Postgraduate, Sichuan University of Science and Engineering(No.y2018057), the Green Catalysis Key Laboratory Open Fund Project of Universities in Sichuan Province(No.LYJ1405)

摘要:

采用水热法将碘氧化铋(BiOI)负载到锌镁铝类水滑石(ZnMgAl-HTLCs)上制备得到BiOI/ZnMgAl-HTLCs可见光催化剂。 通过X射线衍射仪(XRD)、扫描电子显微镜(SEM)、傅里叶变换红外光谱仪(FTIR)等技术手段考察了BiOI负载质量分数、反应温度、反应时间及加料顺序等因素对BiOI/ZnMgAl-HTLCs光催化剂结构及形貌的影响。 结果表明,在制备BiOI/ZnMgAl-HTLCs材料中先加入锌镁铝类水滑石,负载质量分数为40%的BiOI,反应温度为140 ℃,反应时间为24 h,可以得到结晶度高和形貌较好的BiOI/ZnMgAl-HTLCs。

关键词: 锌镁铝类水滑石, 碘氧化铋, 光催化剂

Abstract:

The ZnMgAl hydrotalcite-like compounds(HTLCs) supported bismuth oxyiodide(BiOI)(BiOI/ZnMgAl-HTLCs) visible light photocatalyst was prepared by hydrothermal method. The effects of BiOI loading mass fraction, reaction temperature, reaction time, and addition sequence on the structure and morphology of the BiOI/ZnMgAl-HTLCs photocatalyst were investigated by X-ray diffraction(XRD), scanning electron microscopy(SEM) and Fourier transform infrared spectroscopy(FTIR). The results show that BiOI/ZnMgAl-HTLCs with high crystallinity and good morphology can be obtained by firstly adding BiOI in 40% mass fraction to ZnMgAl-HTLCs at 140 ℃, and keeping reaction for 24 h.

Key words: ZnMgAl hydrotalcite-like compounds, bismuth oxyiodide, photocatalyst