Tunable infrared filter based on elastic polymer springs

Mahmoud Almasri; Weihong Zhang; Allen Kine; Yat Chan; John C. LaRue; Richard Nelson

doi:10.1117/12.601981

9 May 2005 Tunable infrared filter based on elastic polymer springs

Mahmoud Almasri, Weihong Zhang, Allen Kine, Yat Chan, John C. LaRue, Richard Nelson

Proceedings Volume 5770, Advanced Sensor Technologies for Nondestructive Evaluation and Structural Health Monitoring; (2005) https://doi.org/10.1117/12.601981
Event: Nondestructive Evaluation for Health Monitoring and Diagnostics, 2005, San Diego, CA, United States

Abstract

This paper describes the design, fabrication and testing of tunable Fabry-Perot filters. The goal of this research is to develop novel tunable filter with an area of 5x5 mm² that will be used in infrared gas sensors. This exploits the fact that most gases have unique infrared absorption signatures in the 2-14 µm wavelength region. The filter consists of two thin silicon wafers coated with quarter wave dielectric layers to form wavelength dependent high reflection mirrors and separated by air gaps with an average height of 8, 5.1 and 3.5 μm. The mirrors are supported by four elastic polymer posts (springs) each with an area of 100×100 μm² made by using photo definable polydimethylsilxane (PDMS). An electrostatic voltage is used to compress the springs, change the airgap height and hence shift the transmission peaks to a shorter wavelength. A finesse of 12 with full width at half maximum (FWHM) of 70 nm, and a peak transmission of 63% were achieved by applying 100 volts on a device with 8 µm post height and wafer thickness of 125 µm. In addition, the measured tunability before and after hard baking of the device was 210 nm and 130 nm respectively. The tunability stayed constant after hard baking the devices and did not show any changes with time. The tunability was also measured on a thinner silicon mirror with 3.5 µm post height. In this case, the filter was tuned 180 nm by applying 10 volts. However, the filter finesse was 3, transmission peak was 40% and FWHM over 200 nm. An antireflection coating was deposited on one side of silicon wafers and a Fabry-Perot filter to study transmission enhancement and satisfactory results were achieved.

Citation Download Citation

Mahmoud Almasri, Weihong Zhang, Allen Kine, Yat Chan, John C. LaRue, and Richard Nelson "Tunable infrared filter based on elastic polymer springs", Proc. SPIE 5770, Advanced Sensor Technologies for Nondestructive Evaluation and Structural Health Monitoring, (9 May 2005); https://doi.org/10.1117/12.601981

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE

Includes PDF, HTML & Video, when available