American Geophysical Union Become an AGU Member
Subscribe to AGU Journals		 AGU Home AGU Publications

Read Full Article (file size: 1146445 bytes)    Cited by

JOURNAL OF GEOPHYSICAL RESEARCH, VOL. 108, NO. B8, 2398, doi:10.1029/2002JB002314, 2003

Deformation and fluid pressure variation during initiation and evolution of the plate boundary décollement zone in the Nankai accretionary prism

Kohtaro Ujiie

Institute for Frontier Research on Earth Evolution, Japan Marine Science and Technology Center, Yokohama, Japan


Toshio Hisamitsu

Institute for Frontier Research on Earth Evolution, Japan Marine Science and Technology Center, Yokosuka, Japan


Asahiko Taira

Center for Deep Earth Exploration, Japan Marine Science and Technology Center, Yokosuka, Japan


Abstract

The plate boundary décollement zone in the Muroto region of the Nankai accretionary prism records deformation and consolidation histories that have been affected by temporal changes in fluid pressure. Microstructural observations and chemical analysis demonstrate that the décollement zone initiated in an interval of porous clayey sediments characterized by cementation due to intergranular bonding of authigenic clays. Crosscutting relations of microstructures indicate that the décollement zone records two compactive deformations. The early compactive deformation involved destruction of porous cemented structure, probably caused by fluid pressure fluctuation. The late compactive deformation was characterized by clay-particle rotation and porosity collapse along the sets of slip surfaces, resulting in zones of preferred orientation of clay particles. These compactive deformations led to significantly higher bulk densities within the décollement zone compared to the compaction trend of the overlying prism sediments. Elevated fluid pressure following compactive deformations induced an overconsolidated state within the décollement zone, with fluid-filled dilatant fractures. Bulk density abruptly decreases at the top of the underthrust sediments, but there is no microstructural evidence for cementation. Fluids in the dilated fractures and underconsolidated underthrust sediments are potential sources for the elevated fluid pressure in and below the décollement zone, resulting in mechanical decoupling of the accretionary prism from underthrust sediments. The fault-fluid interactions in the Muroto region may be applicable to other convergent plate margins where high temperature associated with the subduction of a spreading ridge or hot, young oceanic crust enhances diagenesis and cementation.

Received 18 November 2002; accepted 28 May 2003; published 28 August 2003.

Index Terms: 8045 Structural Geology: Role of fluids; 8150 Tectonophysics: Plate boundary—general (3040); 8030 Structural Geology: Microstructures; 5114 Physical Properties of Rocks: Permeability and porosity; 1518 Geomagnetism and Paleomagnetism: Magnetic fabrics and anisotropy.

Read Full Article (file size: 1146445 bytes)    Cited by

Citation: Ujiie, K., T. Hisamitsu, and A. Taira (2003), Deformation and fluid pressure variation during initiation and evolution of the plate boundary décollement zone in the Nankai accretionary prism, J. Geophys. Res., 108(B8), 2398, doi:10.1029/2002JB002314.