Observations of methylmercury in precipitation

https://doi.org/10.1016/0048-9697(89)90235-0Get rights and content

Abstract

Using a newly developed technique, methylmercury species have been quantified in several precipitation and lake water samples. Mercury species are determined by aqueous-phase ethylation to the volatile dialkyl analogs, followed by cryogenic gas chromatographic (GC) separation. Mercury-specific detection by cold vapour atomic fluorescence spectrometry permits detection limits of about 0.1 pg as Hg. Snow samples collected from north-central Wisconsin contained monomethylmercury levels of about 0.25 pM (0.05 ng l−1 Hg) and total mercury concentrations of 20 pM (4 ng l−1 Hg). A time series of rain samples collected during a storm passing over the North Olympic Peninsula in western Washington State showed average monomethylmercury levels of 0.75 pM (0.15 ng l−1 Hg), with total mercury concentrations from 10 to 25 pM (2–5 ng l−1 Hg). Total mercury showed a strong washout effect over the course of the storm, while methylmercury appeared to show a diurnal pattern, with elevated levels during the daylight hours. No dimethylmercury was observed in any precipitation sample. Methylmercury was observed in most lakes studied, with a high of 3.1 pM (0.64 ng l−1 Hg) in Onadaga Lake, New York, and a low of < 0.015 pM in Lake Crescent, located in the Olympic Mountains of Washington State.

References (22)

  • T.R. Fogg et al.

    Mercury in southern New England coastal rains

    J. Geophys. Res.

    (1979)
  • Cited by (0)

    View full text