Note
Surface tension of solids: An equation of state analysis

https://doi.org/10.1016/0021-9797(79)90332-1Get rights and content

First page preview

First page preview
Click to open first page preview

References (18)

  • H.W Fox et al.

    J. Colloid Sci.

    (1950)
  • J.R Dann

    J. Colloid Interface Sci.

    (1970)
  • F Schulman et al.

    J. Colloid Sci.

    (1952)
  • R.E Johnson et al.

    J. Colloid Interface Sci.

    (1966)
  • H.W Fox et al.

    J. Colloid Sci.

    (1952)
  • H.W Fox et al.

    J. Colloid Sci.

    (1952)
  • S Wu
  • D.G Legrand et al.

    J. Colloid Interface Sci.

    (1969)
  • J.F Padday
There are more references available in the full text version of this article.

Cited by (70)

  • Advances in surface properties characterization and modification for lignin

    2023, International Journal of Biological Macromolecules
  • Mutual influence of ethanol and surfactin on their wetting and adhesion properties

    2021, Colloids and Surfaces A: Physicochemical and Engineering Aspects
  • Modification of adsorption, aggregation and wetting properties of surfactants by short chain alcohols

    2020, Advances in Colloid and Interface Science
    Citation Excerpt :

    Young stated that the equilibrium of the solid-liquid drop-air systems depends on the interface forces [177]. Van Oss et al. [101,172,173], Neumann et al. [178], Fowkes [174] and Wu [179] derived their equations using the Young equation based on the interface tensions. On the other hand, Rusanov [180] and the other authors [181] prove that the contact angle in the Young equation depends on the interface free energy.

  • Components and parameters of liquids and some polymers surface tension at different temperature

    2017, Colloids and Surfaces A: Physicochemical and Engineering Aspects
    Citation Excerpt :

    In the case of nylon 6 in contrast to PMMA there are the values of electron-acceptor parameter of acid-base component higher than zero and thus for nylon 6 the acid-base component is higher than zero. It results from the fact that on the nylon 6 surface not only CO but also NH groups are present [38]. The influence of the polar intermolecular interactions on nylon 6 surface tension was confirmed by considerable values of polar component determined by both the Owens-Wendt [9] and Wu [35–37] methods (Tables S32–S35).

  • Components and parameters of solid/surfactant layer surface tension

    2017, Colloids and Surfaces A: Physicochemical and Engineering Aspects
View all citing articles on Scopus

Contribution No. 2601.

View full text