Abstract
A centrifugal compressor is a typical compressed air energy storage device. In order to ensure the safety of the compressed energy storage process in the compressor, the internal unsteady flow phenomena need to be closely monitored, especially some serious ones like stall and surge. It is necessary to explore the mechanism of flow instabilities under different conditions. A centrifugal air compressor was tested with a vaneless diffuser and a variable vaned diffuser with five different vane setting angles, respectively. Various diffuser types resulted in various modes of flow instabilities prior to surge. The vaneless region between the impeller and the diffuser was focused on. Multiple high-speed sensors were arranged along the circumferential direction. The pressure signals at all these positions were being measured and collected in real time as the compressor was slowly throttled into surge. This paper emphasizes on the influence of matching between the impeller and the diffuser on the flow instability. The experimental results showed that the diffuser vane setting angle affected the stall characteristics. Due to the asymmetry of the volute, the circumferential pressure distribution was always severely distorted prior to surge. A high-pressure region appeared near the volute tongue, and a low-pressure region was formed away from the volute tongue. In the case of the vaned diffuser with non-design installation angle and the vaneless diffuser, the rotating stall signal was originated in the low-pressure region and propagated circumferentially. However, in the case of the vaned diffuser with the design installation angle, the circumferential high-pressure region became the most sensitive region for the generation of stall, and another form of instability occurred there. Both the inducement and development of these flow instabilities have been studied. The dynamic experimental research on the compressor matching different types of diffusers could be a good case supplement.
Similar content being viewed by others
References
Chen H.S., Cong T.N., Yang W., et al., Progress in electrical energy storage system: A critical review. Progress in Natural Science, 2009, 19(3): 291–312.
Moënne-Loccoz V., Trébinjac I., Benichou E., et al., An experimental description of the flow in a centrifugal compressor from alternate stall to surge. Journal of Thermal Science, 2017, 26(4): 289–296.
Tamaki H., Experimental study on the effect of diffuser vane setting angle on centrifugal compressor performance. Journal of Turbomachinery, 2017, 139(6): 061001.
Tsukamoto K., Okada M., Inokuchi Y., et al., Measurement and numerical simulation of a small centrifugal compressor characteristics at small or negative flow rate. Journal of Thermal Science, 2017, 26(2): 107–112.
Day I.J., Stall, surge, and 75 years of research. Journal of Turbomachinery, 2016, 138(1): 011001.
Greitzer E.M., Surge and rotating stall in axial flow compressors—Part I: Theoretical compression system model. Journal of Engineering for Gas Turbines and Power, 1976, 98(2): 190–198.
McDougall N.M., Cumpsty N.A., Hynes T.P., Stall inception in axial compressors. Journal of Turbomachinery, 1990, 112(1): 116–123.
Day I.J., Stall inception in axial flow compressors. Journal of Turbomachinery, 1993, 115(1): 1–9.
Camp T.R., Day I.J., A study of spike and modal stall phenomena in a low-speed axial compressor. Journal of Turbomachinery, 1998, 120(3): 393–401.
Spakovszky Z.S., Roduner C.H., Spike and modal stall inception in an advanced turbocharger centrifugal compressor. Journal of Turbomachinery, 2009, 131(3): 031012.
Everitt J.N., Spakovszky Z.S., An investigation of stall inception in centrifugal compressor vaned diffuser. Journal of Turbomachinery, 2013, 135(1): 011025.
Xue X., Wang T., Stall recognition for centrifugal compressors during speed transients. Applied Thermal Engineering, 2019, 153: 104–112.
Spakovszky Z.S., Backward traveling rotating stall waves in centrifugal compressors. Journal of Turbomachinery, 2004, 126(1): 1–12.
Pullan G., Young A.M., Day I.J., et al, Origins and structure of spike-type rotating stall. Journal of Turbomachinery, 2015, 137(5): 051007.
Zheng X.Q., Sun Z.Z., Kawakubo T., et al., Experimental investigation of surge and stall in a turbocharger centrifugal compressor with a vaned diffuser. Experimental Thermal and Fluid Science, 2017, 82: 493–506.
Galloway L., Spence S., Kim S.I., Rusch D., et al., An investigation of the stability enhancement of a centrifugal compressor stage using a porous throat diffuser. Journal of Turbomachery, 2017, 140(1): 011008.
Vo H.D., Tan C.S., Greitzer E.M., Criteria for spike initiated rotating stall. Journal of Turbomachery, 2008, 130(1): 011023.
Weichert S., Day I., Detailed measurements of spike formation in an axial compressor. Journal of Turbomachery, 2014, 136(5): 051006.
Xue X., Wang T., Zhang TT., et al., Mechanism of stall and surge in a centrifugal compressor with a variable vaned diffuser. Chinese Journal of Aeronautics, 2018, 31(6): 1222–1231.
Xue X., Wang T., Shao Y.C., et al., Experimental and numerical analysis of different unsteady modes in a centrifugal compressor with variable vaned diffuser. Journal of fluids engineering - Transactions of the ASME, 2019, 141(10): 101106.
Lawless P.B., Fleeter S., Rotating stall acoustic signature in a low-speed centrifugal compressor: part I - vaneless diffuser. Journal of Turbomachery, 1995, 117(1): 87–96.
Acknowledgments
This research was funded by the National Natural Science Foundation of China (Grant No. 51276108) and the Defense Industrial Technology Development Program (B1420110136).
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Xue, X., Wang, T. Experimental Study on Inducement and Development of Flow Instabilities in a Centrifugal Compressor with Different Diffuser Types. J. Therm. Sci. 29, 435–444 (2020). https://doi.org/10.1007/s11630-020-1223-4
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11630-020-1223-4