Abstract
Centrifugal experiments were carried out to investigate the responses of suction bucket foundations under horizontal and vertical dynamic loading. It is shown that when the loading amplitude is over a critical value, the sand at the upper part around the bucket is softened or even liquefied. The excess pore pressure decreases from the upper part to the lower part of the sand layer in the vertical direction and decreases radially from the bucket’s side wall in the horizontal direction. Large settlements of the bucket and the sand layer around the bucket are induced by dynamic loading. The dynamic responses of the bucket with smaller height (the same diameter) are heavier.
Similar content being viewed by others
References
Clukey, E.C., Morrison, M.J., Garnier, J., et al.: The response of suction caissons in normally consolidated clays to cyclic TLP loading conditions. In: Proceedings of Offshore Technology Conference, Houston, OTC 7796, pp. 909–918 (1995)
Allersma, H.G.B., Plenevaux, F.J.A.: Wintgens JFPCME: simulation of suction pile installation in sand in a geocentrifuge. In: Proceedings of the 7th International Offshore and Polar Engineering Conference (ISOPE97), 1:761–765 (1997)
Allersma, H.G.B., Kierstein, A.A., Maes, D.: Centrifuge modeling on suction piles under cyclic and long term vertical loading. In: Proceedings of 10th International Offshore and Polar Engineering Conference, Seattle, USA, International Society of Offshore and Polar Engineers (2000)
Housby G.T. and Byrne B.W. (2000). Suction caisson foundations for offshore wind turbines and anemometer masts. Wind Eng. 24(4): 249–255
Byrne B.W., Housby G.T., Martin C.M. and Fish P.M. (2002). Suction caisson foundations for offshore wind turbines. Wind Eng. 26(3): 145–155
Byrne B.W. and Houlsby G.T. (2004). Experimental investigations of the responses of suction caissons to transient combined loading. ASCE J. Geotech. Geoenviron. Eng. 130(3): 240–253
Andersen, K.H., Jostad, H.P.: Foundation design of skirted foundations and anchors in clay. In: Proceedings of Offshore Technology Conference, Houston, Texas, OTC 10824, pp. 1–10 (1999)
Housby G.T. and Puzrin A.M. (2000). A thermomechanical frame-work for constitutive models for rate-independent dissipative materials. Int. J. Plast 16(9): 1017–1047
Senpere, D., Auvergne, G.A.: Suction anchor piles-a proven alternative to driving or drilling. In: Proceedings of Offshore Technology Conference, Houston, OTC4206, pp. 483–493(1982)
Aas, P.M., Andersen, K.H.: Skirted foundation for offshore structure. In: Proceedings of the 9th Offshore South East Asia Conference, Singapore. World Trade Center Singapore, Singapore, pp. 1–7, (1992)
Dyme, W., Houlsby, G.T.: Drained behavior of suction caisson on very dense sand. In: Proceedings of Offshore Technology Conference, Houston, OTC10994, pp. 765–782 (1998)
Tjelta, T.L., Hermstad, J., Andenaes, E.: The skirt piled gullfaks c platform installation. In: Proceedings of Offshore Technology Conference, Houston, OTC6473, pp. 453–462 (1990)
Bye, A., Erbrich, C., Earl, K., et al.: Geotechnical design of bucket foundation. In: Proceedings of Offshore Technology Conference, Houston, OTC7793, pp. 869–883(1995)
Tjelta, T.I., Guttormsen, T.R., Hermstad, J.: Large-scale penetration test at a deepwater site. In: Proceedings of Offshore Technology Conference, Houston, OTC 5103, pp. 201–212 (1986)
Clukey, E.C.: Suction caisson design issues. OTRC 2001, In: Proceedings of the International Conference Geotechnique, Geological and Geophysical Properties of Deepwater Sediments, Houston, pp. 163–181 (2001)
Cassidy M.J., Byrne B.W. and Randolph M.F. (2004). A comparison of the combined load behavior of spudcan and caisson foundations on soft normally consolidated clay. Geotechnique 54(2): 91–106
Fugsang, L.D., Steensen-Bach, J.O.: Breakout resistance of suction piles in clay. In: Ko, H.Y., Mclean, F.G. (eds.) Proceedings of the International Conference: Centrifuge 91. A.A. Balkema, Rotterdam, The Netherlands, 153–159 (1991)
Jones, W.C., Iskander, M.G., Olson, R.E., et al.: Axial capacity of suction piles in sand. In: Chryssostomidis, C. (ed.) Proceedings of 7th International Conference on the Behavior of Offshore Strucutres. Pergamom, pp. 63–75 (1994)
Steensen-Bach, J.O.: Recent model tests with suction piles in clay and in sand. In: Proceedings of Offshore Technology Conference, Houston, OTC6844, pp. 323–330 (1992)
Luke A.M., Rauch A.F. and Olson R.E. (2005). Components of suction caisson capacity measured in axial pullout tests. Ocean Eng. 32: 878–891
Ding H.Y., Qi L. and Du X.Z. (2003). Estimating soil liquefaction in ice-induced vibration of bucket foundation. J. Cold Reg. Eng. 17(2): 60–67
Lu X.B., Zheng Z.M. and Zhang J.L. (2003). Progress in the study on the bucket foundation of offshore platform. Adv. Mech. 33(1): 27–40, (in Chinese)
Housby G.T. and Byrne B.W. (2005). Design procedures for installation of suction caissons in sand. Geotech. Eng. 158(GE3): 135–144
Housby G.T. and Byrne B.W. (2005). Design procedures for installation of suction caissons in clay and other materials. Geotech. Eng. 158(GE2): 75–82
Taylor R.N. (1995). Geotechnical Centrifuge Technology. Blackie Academic & Professional, London
Lu, X.B., Zhang, X.H., Sun, G.L., et al.: Simulation of dynamic loading in centrifuge modeling for suction bucket foundations. In: Proceedings of 15th International Offshore and Polar Engineering Conference (ISOPE), 19–24 June 2005, 2:423–430
Author information
Authors and Affiliations
Corresponding author
Additional information
The project supported by the fund of Chinese Ocean Oil Co. and Chinese Academy of Sciences(KZCX2-YW-302-02).
Rights and permissions
About this article
Cite this article
Lu, X., Wu, Y., Jiao, B. et al. Centrifugal experimental study of suction bucket foundations under dynamic loading. Acta Mech. Sin. 23, 689–698 (2007). https://doi.org/10.1007/s10409-007-0100-7
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10409-007-0100-7