Abstract
Polyureas (PU) are well known as a class of high impact engineering materials, and widely used also in emerging advanced applications. As a general observation, most of them are only soluble in a very limited number of highly protonic solvents, which makes their chemical structure analysis a great challenge. Besides the presence of abundant hydrogen bonding, the poor solubility of PU in common organic solvents is often ascribed to the formation of biuret crosslinking in their molecular chains. To clarify the presence of biuret groups in PU has been of great interest. To this end, two samples, based on hexamethylene diisocyanate (HDI) and toluene diisocyanate (TDI) respectively, were synthesized by precipitation polymerization of each of these diisocyanates in water-acetone at 30 °C. Their chemical structures were analyzed by high resolution magic angle spinning (HR-MAS) NMR, and through comparison of their NMR spectra with those of specially prepared biuret-containing polyurea oligomers, it was concluded that biuret group was absent in all the PU prepared at 30 °C. In addition, this NMR analysis was also applied to a PU obtained by copolymerization of TDI with ethylene diamine (EDA) and water at 65 °C in EDA aqueous solution. It was confirmed that biuret unit was also absent in this PU and that EDA was more active than water towards TDI. The presence of EDA was crucial to the formation of uniform PU microspheres. This study provides therefore a reliable method for the analysis of PU chemical structure.
Similar content being viewed by others
References
Davidson, J. S.; Fisher, J. W.; Hammons, M. I.; Porter, J. R.; Dinan, R. J. Failure mechanisms of polymer-reinforced concrete masonry walls subjected to blast. J. Struct. Eng. 2005, 131(8), 1194–1205.
Mohotti, D.; Ngo, T.; Mendis, P.; Raman, S. N. Polyurea coated composite aluminium plates subjected to high velocity projectile impact. Mater. Design 2013, 52(24), 1–16.
Samiee, A.; Amirkhizi, A. V.; Nemat-Naser, S. Numerical study of the effect of polyurea on the performance of steel plates under blast loads. Mech. Mater. 2013, 64(9), 1–10.
Ley, S. V.; Mitchell, C.; Pears, D.; Ramarao, C.; Yu, J. Q.; Zhou, W. Recyclable polyurea microencapsulated Pd nanoparticles: An efficient catalyst for hydrogenolysis of epoxides. Org. Lett. 2003, 5(24), 4665–4668.
Han, H.; Zhou, Y.; Li, S.; Wang, Y.; Kong, X. Z. Immobilization of lipase from pseudomon as fluorescens on porous polyurea and its application in kinetic resolution of racemic 1-phenylethanol. ACS Appl. Mater. Interfaces 2016, 8(39), 25714–25724.
Jiang, X.; Yu, Y.; Li, X.; Kong, X. Z. High yield preparation of uniform polyurea microspheres through precipitation polymerization and their application as laccase immobilization support. Chem. Eng. J. 2017, 328, 1043–1050.
Jacquemond, M.; Jeckelmann, N.; Ouali, L.; Haefliger, O. P. Perfume-containing polyurea microcapsules with undetectable levels of free isocyanates. J. Appl. Polym. Sci. 2009, 114(5), 3074–3080.
Li, J.; Hughes, A. D.; Kalantar, T. H.; Drake, I. J.; Tucker, C. J.; Moore, J. S. Pickering-emulsion-templated encapsulation of a hydrophilic amine and its enhanced stability using poly(allyl amine). ACS Macro Lett. 2014, 3(10), 976–980.
Chen, L.; Xu, L.; Shang, H.; Zhang. Z. Microencapsulation of butyl stearate as a phase change material by interfacial polycondensation in a polyurea system. Energ. Convers. Manage. 2009, 50(3), 723–729.
Ying, H.; Zhang, Y.; Cheng, J. Dynamic urea bond for the design of reversible and self-healing polymers. Nat. Commun. 2014, 5, 3218.
Howarth, G. Polyurethanes, polyurethane dispersions and polyureas: Past, present and future. Surf. Coat. Int. Part B Coat. Trans. 2003, 86(2), 111–118.
Jiang, X.; Li, X.; Zhu, X.; Kong, X. Z. Preparation of highly uniform polyurea microspheres through precipitation polymerization and their characterization. Ind. Eng. Chem. Res. 2016, 55(44), 11528–11535.
Jiang, X.; Kong, X. Z.; Zhu, X. A Novel protocol for the preparation of uniform polymer microspheres with high yields through step polymerization of isophorone diisocyanate. J. Polym. Sci., Part A: Polym. Chem. 2011, 49(20), 4492–4497.
Sumi, M.; Chokki, Y.; Nakai, Y.; Nakabayashi, M.; Kanzawa, T. Studies on the structure of polyurethane elastomers. I. NMR spectra of the model compounds and some linear polyurethanes. Die Makromol. Chem. 1964, 78(1), 146–156.
Chattopadhyay, D. K.; Raju, K. V. S. N. Structural engineering of polyurethane coatings for high performance applications. Prog. Polym. Sci. 2007, 32(3), 352–418.
Suzuoki, K.; Kagawa, K.; Fukuma, K.; Uda, B.; Ohmura, J. The analysis of synthetic and side reactions of polyurethaneurea. Nippon Gomu Kyokaishi 1999, 72, 139–143.
Mathisen, R. J.; Yoo, J. K.; Sung, C. S. P. Dye labeling technique for monitoring the cure of polyimides and polyureas: Model compound studies. Macromolecules 1987, 20(6), 1414–1416.
Okuto, H. Studies on the structure of polyurethane elastomers. II. High resolution NMR spectroscopic determination of allophanate and biuret linkages in the cured polyurethane elastomer: Degradation by amine. Die Makromol. Chem. 1966, 98(1), 148–163.
Delebecq, E.; Pascault, J.; Boutevin, B.; Ganachaud, F. On the Versatility of urethane/urea bonds: Reversibility, blocked isocyanate, and non-isocyanate polyurethane. Chem. Rev. 2013, 113(1), 80–118.
Zhang, X.; Zhang, X. Y.; He, Y.; Chen, H. Progress in synthesis and characterization of HDI biuret. Pain Coat. Ind. 2011, 41(10), 71–75.
Lapprand, A.; Boisson, F.; Delolme, F.; Méchin, F.; Pascault, J. P. Reactivity of isocyanates with urethanes: conditions for allophanate formation. Polym. Degrad. Stab. 2005, 90(2), 363–373.
Jiang, X.; Zhu, X.; Arnold, A. A.; Kong, X. Z.; Claverie, J. P. Polyurea structure characterization by HR-MAS NMR spectroscopy. Ind. Eng. Chem. Res. 2017, 56(11), 2993–2998.
Han, H.; Li, S.; Zhu, X.; Jiang, X.; Kong, X. Z. One step preparation of porous polyurea by reaction of toluene diisocyanate with water and its characterization. RSC Adv. 2014, 4(63), 33520–33529.
Jiang, X.; Zhu, X.; Kong, X. Z. A facile route to preparation of uniform polymer microspheres by quiescent polymerization with reactor standing still without any stirring. Chem. Eng. J. 2012, 213(12), 214–217.
Kong, X. Z.; Jiang, W.; Jiang, X.; Zhu, X. Preparation of coreshell and hollow polyurea microspheres via precipitation polymerization using polyamine as crosslinker monomer. Polym. Chem. 2013, 4(24), 5776–5784.
Li, S. S.; Han, H.; Zhu, X.; Jiang, X.; Kong, X. Z. Preparation and formation mechanism of porous polyurea by reaction of toluene diisocyanate with water and its Application as adsorbent for anionic dye removal. Chinese J. Polym. Sci. 2015, 33(8), 1196–1210.
Li, S.; Zhu, X.; Kong, X. Z.; Jiang, X. One step synthesis of porous polyurea by using TDI and EDA and its characterization. Acta Polymerica Sinica (in Chinese) 2016, (3), 391–398.
Yang, Y.; Jiang, X.; Zhu, X.; Kong, X. Z. A facile pathway to polyurea nanofiber fabrication and polymer morphology control in copolymerization of oxydianiline and toluene diisocyanate in acetone. RSC Adv. 2015, 5(10), 7426–7432.
Alam, T. M.; Jenkins, J. E. “Advanced Aspects of Spectroscopy”, Intech, Croatia, 2012, p. 279–301.
Li, S.; Zhao, J.; Zhang, Z.; Zhang, J.; Yang, W. Aliphatic thermoplastic polyurethane-ureas and polyureas synthesized through a non-isocyanate route. RSC Adv. 2015, 5(9), 6843–6852.
Harris, R. F.; Kinney, J. E.; Savina, M. R.; Jeor, V. L. S.; Bicerano, J.; Durvasula, V. R.; Moreno, L. N. Synthesis and characterization of urea-based polyureas: 1. Urea-terminated poly(1,6-hexamethyleneurea) polyol dispersions. Polymer 1995, 36(22), 4275–4285.
Edwards, P. A.; Striemer, G.; Webster, D. C. Synthesis, characterization and self-crosslinking of glycidyl carbamate functional resins. Prog. Org. Coat. 2006, 57(2), 128–139.
Wendisch, D.; Reiff, H.; Dieterich, D. Kernresonanzspektroskopische beiträge zur struktur und stereochemie von (cyclo)aliphatischen isocyanaten und deren folgeprodukten. Angew. Makromol. Chem. 1986, 141(1), 173–183.
Zhang, F.; Jiang, X.; Zhu, X.; Chen, Z.; Kong, X. Z. Preparation of uniform and porous polyurea microspheres of large size through interfacial polymerization of toluene diisocyanate in water solution of ethylene diamine. Chem. Eng. J. 2016, 303, 48–55.
Entelis, S. G.; Nesterov, O. V. Kinetics and mechanism of the reactions of isocyanates with compounds containing “active” hydrogen. Russ. Chem. Rev. 1966, 35(12), 917–930.
Lu, X.; Wang, Y.; Wu, X. Molecular interactions in polyurea by 1-D and 2-D NMR. Polymer 1993, 34(1), 56–60.
Acknowledgments
This work was financially supported by the National Natural Science Foundation of China (Nos. 21274054, 21304038 and 51473066), Research Foundation of University of Jinan (No. XKY1604) and by Science & Technology Development Plan of Shandong Province (No. 2017GGX202009), China.
Author information
Authors and Affiliations
Corresponding authors
Rights and permissions
About this article
Cite this article
Qiu, WG., Zhang, FL., Jiang, XB. et al. NMR Analysis to Identify Biuret Groups in Common Polyureas. Chin J Polym Sci 36, 1150–1156 (2018). https://doi.org/10.1007/s10118-018-2130-y
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10118-018-2130-y