Electrochemical oxidation of a carbon black loaded polymer electrode in aqueous electrolytes

Abstract

The suitability of a polymeric composite material for use as part of an anode structure in a cathodic protection system has been examined. The composite material was a conductive blend (volume resistivity typically 1.5 Ω cm) of carbon black in a polyethylene binder. A long operational lifetime for the material demands that the rate of carbon loss must be low. In the work reported here, electrochemical and in situ analytical techniques were employed to characterise the performance of the material over a wide range of anodic current densities in a variety of aqueous electrolytes. The predominant anodic electrochemical reaction on the polymeric material is CO₂ formation in acid and neutral solutions, which causes loss of carbon from the surface and the development of a non-conducting layer of polyethylene. The characteristics of the reaction suggest that it occurs via the discharge of H₂O. In alkaline pH, however, the anodic reactions are more complex. A high OH⁻ concentration (pH 12 or higher) favours the formation of oxygen rather than CO₂, particularly at low anodic potentials. The presence of CO₃ ²⁻ in the electrolyte catalyses the evolution of oxygen at pH values as low as 9. The electrochemical formation of oxygen always occurs in parallel with the generation of some humic acid in the solution.