Skip to main content
Log in

Optimal design of wavy microchannel and comparison of heat transfer characteristics with zigzag and straight geometries

  • Original
  • Published:
Heat and Mass Transfer Aims and scope Submit manuscript

Abstract

Design concept of microchannel heat exchangers is going to plan with new flow microchannel configuration to reduce the pressure drop and improve heat transfer performance. The study aims to find optimum microchannel design providing the best performance of flow and heat transfer characterization in a heat sink. Therefore, three different types of microchannels in which water is used, straight, wavy and zigzag have been studied. The optimization operation has been performed to find optimum geometry with ANSYS’s Response Surface Optimization Tool. Primarily, CFD analysis has been performed by parameterizing a wavy microchannel geometry. Optimum wavy microchannel design has been obtained by the response surface created for the range of velocity from 0.5 to 5, the range of amplitude from 0.06 to 0.3, the range of microchannel height from 0.1 to 0.2, the range of microchannel width from 0.1 to 0.2 and range of sinusoidal wave length from 0.25 to 2.0. All simulations have been performed in the laminar regime for Reynolds number ranging from 100 to 900. Results showed that the Reynolds number range corresponding to the industrial pressure drop limits is between 100 and 400. Nu values obtained in this range for optimum wavy geometry were found at a rate of 10% higher than those of the zigzag channel and 40% higher than those of the straight channels. In addition, when the pressure values of the straight channel did not exceed 10 kPa, the inlet pressure data calculated for zigzag and wavy channel data almost coincided with each other.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Fig. 13
Fig. 14
Fig. 15

Similar content being viewed by others

Abbreviations

a :

Amplitude [m].

b :

Microchannel height [m].

c :

Microchannel width [m].

c p :

Specific heat [kj/kgK].

dp/dx :

Pressure gradient [kg/m2 s2].

D h :

Hydraulic diameter [m].

e :

Internal energy [J/kg].

f:

Friction factor.

h :

Heat transfer coefficient [W/(m2 K].

k :

Thermal conductivity [W/mK].

L :

Microchannel length [m].

Nu :

Nusselt number.

p :

Pressure [N/m2].

q :

Heat flux [W/m2].

Re :

Reynolds number.

S :

Wave length [m].

t :

Time [s].

T :

Temperature [K].

U :

Velocity [m/s].

δ :

Identity matrix.

μ :

Dynamic viscosity [kg/(m s)].

ρ :

Density [kg/m3].

τ :

Stress tensor [N/m2].

f :

(Fluid)

m :

(Mean)

s :

(Surface)

w :

(Wall)

References

  1. Baheri Islami S, Dastvareh B, Gharraei R (2014) An investigation on the hydrodynamic and heat transfer of nanofluid flow, with non-Newtonian base fluid, in micromixers. Int J Heat Mass Transf 78:917–929

    Article  Google Scholar 

  2. Adams TM, Abdel-Khalik SI, Jeter SM, Qureshi ZH (1998) An experimental investigation of single-phase forced convection in microchannels. Int J Heat Mass Transf 41:851–857

    Article  Google Scholar 

  3. Yu D, Warrington R, Barron R, Ameel T (1995) Experimental and theoretical investigation of friction factor and heat transfer in microtubes, ASME/JSME thermal engineering Conf. 523–553 Hawaii

  4. Celata GP, Cumo M, Guglielmi M, Zummo G (2002) Experimental investigation of hydraulic & single-phase heat transfer in 0.13 mm capillary tube. Microscale Thermophysical Engineering 6:85–97

    Article  Google Scholar 

  5. Tso CP, Mahulikar SP (1998) The use of the brinkman number for single phase forced convective heat transfer in microchannels. Int J Heat and Mass Transfer 41(12):1759–1769

    Article  Google Scholar 

  6. Lelea D, Nishio S, Takano K (2004) The experimental research on microtube heat transfer and fluid flow of distilled water. Int J Heat Mass Transf 47:2817–2830

    Article  Google Scholar 

  7. Celata GP, Cumo M, Marconi V, Mcphail SJ, Zummo G (2006) Microtube liquid single-phase heat transfer in laminar flow. Int J Heat Mass Transf 49:3538–3546

    Article  Google Scholar 

  8. Li Z, He YL, Tang GH, Tao WQ (2007) Experimental and numerical studies of liquid flow and heat transfer in microtubes. International Journal of Heat and Mass Trans 50:3447–3460

    Article  Google Scholar 

  9. Zhigang L, Ning G, Chengwu Z, Xiaobao Z (2009) Experimental study on flow and heat transfer in a 19.6 μm microtube. Experimental Heat Transfer 22:178197

    Article  Google Scholar 

  10. Parlak N, Gür M, Arı V, Küçük H, Engin T (2011) Second law analysis of water flow through smooth microtubes under adiabatic conditions. Exp Thermal Fluid Sci 35(1):60–67

    Article  Google Scholar 

  11. Peng XF, Peterson GP, Wang BX (1994) Frictional flow characteristics of water flowing through microchannels. Experimental Heat Transfer 7:249–264

    Article  Google Scholar 

  12. Wang BX, Peng XF (1994) Experimental investigation on liquid forced convection heat transfer through microchannels. Int J Heat Mass Transf 37

    Article  Google Scholar 

  13. Peng XF, Peterson GP (1996) Convective heat transfer & friction for water flow in micro- channel structures. Int J Heat Mass Transf 39:2599–2608

    Article  Google Scholar 

  14. Harms TM, Kasmierczak MJ, Gerner FM (1999) Developing convective heat transfer in deep rectangular microchannels. Int J Heat Fluid Flow 20:149157

    Article  Google Scholar 

  15. Gao P, Le Person S, Favre-Marinet M (2000) Scale effect on hydrodynamics and heat transfer in two-dimensional mini and microchannels. Int J Thermal Sciences 41:1017–1027

    Article  Google Scholar 

  16. Fernando P, Palm P, Ameel T, Lundqvist P, Granryd E (2008) A minichannel aluminium tube heat exchanger – part I: evaluation of single-phase heat transfer coefficients by the Wilson plot method. Int J of Refrigeration 31:669–680

    Article  Google Scholar 

  17. Lee PS, Garimella SV, Liu D (2005) Investigation of heat transfer in rectangular microchannels. Int. J. Heat and Mass Transfer 48:1688–1704

    Article  Google Scholar 

  18. Tiselj I, Hetsroni G, Mavko B, Mosyak A, Pogrebnyak E, Segal Z (2004) Effect of axial conduction on the heat transfer in micro-channels. Int J Heat Mass Transf 47:2551–2565

    Article  Google Scholar 

  19. Ma DD, Xia GD, Li YF, Jia YT, Wang J (2016) Design study of micro heat sink configurations with offset zigzag channel for specific chips geometrics. Energy Convers Manag 127(1):160–169

    Article  Google Scholar 

  20. Dai Z, Fletcher DF, Haynes BS (2015) Impact of tortuous geometry on laminar flow heat transfer in microchannels. Int J Heat Mass Transf 83:382–398

    Article  Google Scholar 

  21. Rostami J, Abbassi A, Saffar-Avval M (2015) Optimization of conjugate heat transfer in wavy walls microchannels. Appl Therm Eng 82(5):318–328

    Article  Google Scholar 

  22. Sui Y, Teo CJ, Lee PS, Chew YT, Shu C (2010) Fluid flow and heat transfer in wavy microchannels. Int J Heat Mass Transf 53(13–14):2760–2772

    Article  Google Scholar 

  23. Sui Y, Lee PS, Teo CJ (2011) An experimental study of flow friction and heat transfer in wavy microchannels with rectangular cross section. Int J Therm Sci 50(2):2473–2482

    Article  Google Scholar 

  24. Nandi TK, Chattopadhyay H (2013) Numerical investigations of simultaneously developing flow in wavy microchannels under pulsating inlet flow condition. International Communications in Heat and Mass Transfer:27–31

    Article  Google Scholar 

  25. Mohammed HA, Gunnasegaran P, Shuaib NH (2011) Numerical simulation of heat transfer enhancement in wavy microchannel heat sink. International Communications in Heat and Mass Transfer 38(1):63–68

    Article  Google Scholar 

  26. Fabbri G (2000) Heat transfer optimization in corrugated wall channels. Int J of Heat and Mass Trans 43:4299–4310

    Article  Google Scholar 

  27. Chua JC, Teng JT, Xu T, Huang S, Jin S, Yu X, Dang T, Zhang C, Greif R (2012) Characterization of frictional pressure drop of liquid flow through curved rectangular microchannels. Exp Thermal Fluid Sci 38:171–183

    Article  Google Scholar 

  28. Qu WL, Mala GM, Li DQ (2000) Pressure-driven water flows in trapezoidal silicon microchannels. Int J Heat Mass Transf 43:353–364

    Article  Google Scholar 

  29. Wu HY, Cheng P (2003) Friction factors in smooth trapezoidal silicon microchannels with different aspect ratios. Int J Heat Mass Transf 46:25192525

    Google Scholar 

  30. White FW (1991) Viscous fluid flow, pp 569. McGraw-Hill, NewYork

    Google Scholar 

Download references

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Zekeriya Parlak.

Additional information

Publisher’s Note

Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Parlak, Z. Optimal design of wavy microchannel and comparison of heat transfer characteristics with zigzag and straight geometries. Heat Mass Transfer 54, 3317–3328 (2018). https://doi.org/10.1007/s00231-018-2375-6

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s00231-018-2375-6

Navigation