Abstract
C/SiC composites prepared by chemical vapor infiltration (CVI) were subjected to a stationary loading of 160 MPa in a combustion gas environment with flame temperature of 1300 °C. Lifetime of C/SiC composites in such environment was measured. Microstructures of the composites after the testing were also characterized by SEM. The experimental results indicate the lifetime of C/SiC composites is average 2.3 hours in combustion gas environments. The combustion gas flow accelerates the damage of carbon fibers and the failure of the composites by speeding up the diffusion of gas reactants and products, destroying the layer of SiO2 on the surface of SiC coating and bringing fused SiO2 inside the composites. The fracture face of C/SiC is uneven, i e, a flat area close to the windward side and a pulling-out of long fibers near the leeward side, which results from the directionality effect of the combustion gas flow.
Similar content being viewed by others
References
Zhang L T, Cheng L F. Discussion on Strategies of Sustainable Development of Continuous fiber Reinforced Ceramic Matrix Composites[J]. Acta Material Composite Sinica, 2007, 24(2): 1–6
Naslain R. SiC-matrix Composites: Nonbrittle Ceramics for Thermo-structural Application[J]. International Journal of Applied Ceramic Technology, 2005, 2(2): 75–84
Cheng L F, Xu Y D, Zhang L T, et al. Oxidation Behavior of three Dimensional C/SiC Composites in Air and Combustion gas Environments[J]. Carbon, 2000, 38(15): 2103–2108
Yin X W, Cheng L F, Zhang L T, et al. Oxidation Behavior of 3D C/SiC Composites in Two Oxidizing Environments[J]. Composites Science and Technology, 2001, 61(7): 977–980
Filsinger D, Münz S, Schulz A, et al. Experimental Assessment of Fiber-reinforced Ceramics for Combustor Walls[J]. Journal of Engineering for Gas Turbines and Power, 2001, 123(2): 271–276
Graziani T, Baxter D, Nannetti C A. Degradation of Silicon Carbide-based Materials in a High Temperature Combustion Environment[J]. Key Engineering Materials, 1996, 113: 153–164
Sanokawa Y, Ido Y, Sohda Y. Application of Continuous fiber Reinforced Silicon Carbide Matrix Composites to a Ceramic Gas Turbine Model for Automobiles[J]. Ceramic Engineering and Science Proceedings, 1997, 18(4): 221–228
Calomino A, Verrilli M J, Thomas D J. Stress/life Behavior of C/SiC Composites in a Low Partial Pressure of Oxygen Environment Part II: Stress Rupture Life and Residual Strength Relationship[J]. Ceramic Engineering and Science Proceedings, 2002, 23(3): 443–451
Mei H, Cheng L F, Luan X G, et al. Simulated Environments Testing System for Advanced Ceramic Matrix Composites[J]. International Journal of Applied Ceramic Technology, 2006, 3(3): 252–257
Author information
Authors and Affiliations
Corresponding author
Additional information
Funded by the Natural Science Foundation of China (No. 50820145202) and the Natural Science Basic Research Plan in Shaanxi Province of China (No.2009JQ6005)
Rights and permissions
About this article
Cite this article
Zhang, J., Luan, X. & Zhang, L. Microstructure characterization of 3D C/SiC composites in combustion gas environments. J. Wuhan Univ. Technol.-Mat. Sci. Edit. 25, 957–961 (2010). https://doi.org/10.1007/s11595-010-0128-6
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11595-010-0128-6