Elsevier

Journal of Catalysis

Volume 199, Issue 2, 25 April 2001, Pages 209-216
Journal of Catalysis

Regular Article
Oxidation Activity and 18O-Isotope Exchange Behavior of Cu-Stabilized Cubic Zirconia

https://doi.org/10.1006/jcat.2001.3173Get rights and content

Abstract

A series of Cu–ZrO2 samples with varying concentrations of Cu from 1 to 33 mol% have been prepared by sol–gel technique and calcined at 873 K. XRD characterization of the samples with a copper content of 2 to 20 mol% reveals the stabilization of zirconia into cubic (fluorite) phase. The Cu–ZrO2 samples with higher Cu content (>20 mol%) revealed the presence of bulk CuO. A linear decrease in lattice parameter with increase in Cu content up to 20 mol% indicates the possible incorporation of Cu2+ in the lattice position of Zr4+ ions. XPS data of these samples provide further evidence for the incorporation of Cu2+ ions in the ZrO2 lattice up to 5 mol%. At higher concentrations of Cu, about half of the input of Cu goes into the lattice and the remaining stays as extra lattice Cu, possibly on the surface or subsurface layer of ZrO2. The BET surface area of these samples was in the range of 2 to 8 m2 g−1. The activity of these samples in CH4 and CO oxidation was investigated by 18O-isotope exchange as well as by catalytic reaction studies in complete oxidation of CH4 and CO. The Cu–ZrO2 with 20 mol% Cu was found to be the most active sample in the series, which has the maximum amount of copper in the substitutional position. For comparison, yttrium-stabilized zirconia samples with and without Cu was also prepared following the same procedure. Yttrium-stabilized zirconia without Cu was almost inactive in complete methane oxidation, whereas Cu-containing sample was more active. This confirms that the presence of Cu species in substitutional positions along with oxygen vacancies in zirconia lattice are substantially responsible for the catalytic activity in CH4 and CO oxidation as well as in complete heterogeneous 18O exchange processes. The light-off temperature for 50% conversion of CH4 (T50) decreases with an increase in Cu content up to 20 mol% and matches well with the results of 18O exchange measurements. The shapes of the curves of T50 and Texchange follow a similar trend indicating that both CH4 oxidation and 18O exchange processes occur via a completely heterogeneous mechanism.

References (20)

  • K. Tanabe et al.

    Catal. Today

    (1994)
  • R.X. Zhou et al.

    Appl. Catal. A

    (1997)
  • A. Keshavaraja et al.

    Appl. Catal. B

    (1996)
  • L.J. Kundakovic et al.

    Appl. Catal. A

    (1998)
  • E. Kemnitz et al.

    Thermochim. Acta

    (1993)
  • S. Larsson et al.

    Chem. Phys. Lett.

    (1977)
  • H. Arai et al.

    Appl. Catal.

    (1986)
  • S. Cimino et al.

    Catal. Today

    (2000)
  • K.S. Mazdiyasni et al.

    J. Am. Ceram. Soc.

    (1967)
There are more references available in the full text version of this article.

Cited by (60)

  • Steering the methanol steam reforming performance of Cu/ZrO<inf>2</inf> catalysts by modification of the Cu-ZrO<inf>2</inf> interface dimensions resulting from Cu loading variation

    2021, Applied Catalysis A: General
    Citation Excerpt :

    We are able to provide information on the change in lattice parameter, crystallite size and microstrain as a function of Cu loading and, thus, the Cu-ZrO2 interface dimension as derived from Rietveld refinement of the ex situ collected XRD patterns (Fig. 4). Previous work showed that the lattice parameters and unit cell volume of ZrO2 decrease with Cu substitution in the ZrO2 lattice [32]. However, there is no significant change in the lattice parameters and unit cell volume with increasing Cu content in our case (Panel A).

  • Cubic Cu<inf>x</inf>ZrO<inf>100-x</inf> as an efficient and selective catalyst for the oxidation of aromatics active methyl, alcohol, and amine groups

    2021, Polyhedron
    Citation Excerpt :

    The high thermal stability of cubic ZrO2 (2400 °C) as compared to its analogues, i.e., monoclinic (1100 °C) and tetragonal (1400 °C) [17] and the presence of both acidic and basic sites on the surface, and it makes an excellent candidate for redox type of catalysis [18]. Furthermore, zirconia was stabilized into the cubic phase using copper and nickel oxide and used for light alkane oxidation [19,20]. Considering these points, herein, we have developed a facile synthetic method for the synthesis of active Cu-containing Zr-supported metal oxide catalysts by a co-precipitation-hydrothermal method at milder temperatures.

  • Abatement of Volatile Organic Compounds Emission as a Target for Various Human Activities Including Energy Production

    2018, Advances in Inorganic Chemistry
    Citation Excerpt :

    Furthermore, the active phase is very often deposited on a support characterized by an expanded surface area. The support in catalysts for VOCs combustion can play an important role: Al2O3,49,59,101–106 TiO2,107–115 ZrO2,48,53,116–118 CeO2,41,119–124 Nb2O5,125 SnO2,126,127 Cr2O3,128,129 MnO2,130,131 mesoporous silica,57,132–137 zeolites,137–148 clays,149–154 or even various carbons.39,50,155–157 The deposition of the active phase on a porous support not only increases its dispersion and limits consumption of expensive ingredients used in the catalyst production but also results in the appearance of specific properties related to synergetic effects of the system components.

  • On the bifunctional nature of Cu/ZrO<inf>2</inf> catalysts applied in the hydrogenation of ethyl acetate

    2017, Journal of Catalysis
    Citation Excerpt :

    Zirconia was investigated for redox reactions doped with other metal oxides, which changed its phase composition [3], and its utilization as active material was investigated in detail [7,8]. In particular, zirconia was used in hydrogenation reactions [9,10], hydrogen generation by direct oxidation of hydrocarbons [11], and CO oxidation [12]. Although there were many different doping materials tested, the focus was often on catalysts containing Cu as active component.

View all citing articles on Scopus
1

To whom correspondence should be addressed. E-mail: [email protected].

View full text